Parts for Kenmore 911.9207316 (9119207316, 911 9207316): Body Section Parts

Includes 12 washers.

This replacement screw secures appliance components so panels, brackets, and assemblies stay tight and aligned. Replace stripped or missing hardware to eliminate rattles and keep your unit assembled safely and correctly.

• Fastens panels, brackets, or components to the appliance frame
• Restores a secure fit when the original screw is lost, stripped, or corroded
• Helps prevent vibration noise and movement during operation
• Supports proper alignment of trim and assemblies

• Disconnect power; for gas units, also shut off the gas supply
• Use the correct driver to avoid stripping the head; do not overtighten
• Inspect and address damaged mating threads, clips, or brackets before reinstalling
• Refer to your model's parts diagram to confirm location and quantity

This round plug button is a small replacement trim plug that snaps into place to cover unused holes or fastener openings, keeping the appliance finish neat and protecting internal components from dust and debris. What it does

• Covers and protects unused openings or mounting holes in appliance panels
• Keeps dirt, moisture and small debris out of internal cavities
• Restores a clean, finished appearance to damaged or missing trim plugs
• Commonly used where a low-profile, snap-in plug is needed

• One round plug button

• Disconnect power to the appliance before servicing when applicable
• Press the plug squarely into the opening until it snaps into place; some models may require gentle pry to remove
• Use a non-marring tool for removal to avoid scratching surrounding surfaces

This cover screw secures appliance panels and covers, keeping components protected and aligned. Replace missing, stripped, or corroded screws to restore a tight fit and help eliminate rattles, gaps, or panels that won't stay in place.

• Attaches an access cover or panel to the appliance frame
• Helps maintain proper alignment to protect internal components
• Replaces missing, stripped, or rusted hardware
• Typical signs: loose or rattling panel, cover won't stay secure, damaged or rounded screw head

• Disconnect power before servicing
• Support the panel while removing and installing screws to prevent misalignment
• Start threads by hand to avoid cross-threading; do not overtighten
• Use a matching driver bit to avoid damaging the screw head