Parts for Troy-Bilt 15006: Bolo Tines, Wheels Parts

The Frigidaire PureSource Plus WFCB Refrigerator Water Filter is an OEM part for Frigidaire refrigerators. This water filter is specifically engineered to reduce impurities and contaminants in your drinking water and ice, including chlorine taste and odor, lead, cysts, and particulates. 

Regular replacement of the water filter is recommended to maintain the best water quality and flow rate. Over time, the filter can become clogged with particles and contaminants, which can reduce its effectiveness and potentially affect the taste and odor of your water.

Symptoms of a filter that needs replacement include:

• Reduced water flow from the dispenser
• Unpleasant taste or odor in the water and ice
• The refrigerator's water filter indicator light turns on

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

This left-hand bolo tine is a replacement part used for a tiller. This part is constructed of black metal and requires a wrench set for installation. This tine easy to install. The left-hand bolo tine attaches to the left tine holder and is used to dig up dirt in the area being tilled. This is a genuine OEM part sourced directly from the manufacturer and is sold individually.The left-hand bolo tine should be replaced if it is damaged or no longer working. If the tines become so worn that they are pointed, the tiller will not perform acceptably. The tiller will not dig as deeply nor will chop garden residues and cover crops. The tines are typically to be replaced as a set rather than individually.To replace the tines, begin by removing the sheer bolt with a wrench that connects the tine assembly to the tine shaft. Next by using either a wrench or small impact driver, remove all nuts and bolts disconnecting the tines from the tine holder. Replace the left-hand and right-hand tines, tightening with either a wrench or small impact driver, and reattach the tine holder assembly to the tiller securing it with the sheer bolt. The tines should slant into the inside of the tine holder. The tiller is now ready for use. This part is manufactured by Troy-Bilt and MTD.