Brute Tractor

Flange bearing for lawn tractors and walk-behind mowers. Replace when you notice excessive noise, wobbling, or difficulty with blade rotation. Verify fit with your model number before ordering.

Flange bearing for lawn tractors and walk-behind mowers. Replace if you notice excessive noise, vibration, or wheel wobble. Verify fit with your model number.

This is a bushing made from black plastic with a cleft down the middle to provide enough flex for easy insertion. It has a flanged design, which means it won’t easily pop out after installation, even under stress from constant vibration. The bushing’s primary purpose is to protect wires and cables from damage as they pass through a channel. As such, the material is fairly durable and does not need to be replaced under ordinary circumstances. That said, there are some situations in which it can become damaged. For one thing, it’s easy to damage while repairing the wires or cables that run through the bushing. If the bushing does need to be replaced, it requires disconnecting any cables or wires that run through the bushing. Pop out the old bushing with a rubber mallet, install the new bushing the same way, reconnect the wires, and the repair is complete. This is an OEM part sourced directly from MTD, and it is sold individually. It was initially used on snowblowers but has also been used on lawnmowers and lawn tractors.

Replace worn blades causing uneven cuts or poor grass discharge. High lift blade creates suction for better clipping removal in deep or wet grass.

Drive belt for lawn tractors, transfers power to operate mower components. Replace when worn, cracked, or slipping. Verify fit with your model number.

Drive belt for lawn tractor transmission systems. Replace if you notice slipping, squealing, or loss of power. Verify fit with your model number.

Stops blade movement when mower is disengaged. Replace if blades won't stop spinning after shutting off. Typical repair takes 30-45 minutes.

Engine oil filter removes contaminants from mower oil during operation. Replace when clogged or during regular maintenance to protect engine. Verify fit with your engine model number.

Hex head cap screw for lawn tractor assembly. Replace if stripped, rusted, or missing to secure structural components. 7/16-20 thread, 2.75-inch length.