Parts for Electrolux EFDE210TIW01: Burner Parts

This replacement pump assembly moves and removes water to restore normal appliance drainage and reduce standing water or leaks. It's a direct-fit service part designed to bring back proper water flow and quiet operation. What it does:

• Pumps water out of the appliance to enable normal draining and cycle completion
• Can resolve symptoms like standing water, incomplete cycles, or intermittent draining
• Helps address related drain or pump fault indications reported by the appliance

• Always disconnect power to the appliance before starting any repair
• Turn off water supply and drain residual water where applicable to avoid spills
• Remove access panels and mount hardware; note wire and hose locations before disconnecting
• After installation, restore power/water, run a short cycle, and inspect for leaks and proper operation

This dual radiant surface heating element restores reliable burner performance on electric glass-ceramic cooktops and ranges. It delivers selectable 240V output—use the 700W inner ring or the 1900W outer ring—to match pan size and heat efficiently.

• Heats the selected surface burner zone when the control is turned on
• Two heating areas (inner/outer) let you choose power for small or large cookware
• Common symptoms of a failed element: burner won't heat, only one ring heats, uneven heating, or visible hot spots/damage on the element
• Rated 240V; 1900W (outer) + 700W (inner)

• Disconnect power at the breaker before servicing
• Lift/remove the cooktop to access the element; support the glass to prevent stress or cracks
• Note wire locations and transfer one at a time to the new element
• Reuse existing brackets/clips; do not overtighten fasteners against the ceramic base

This replacement switch assembly restores on/off/control functions so your appliance responds correctly to user input. It fits the original mounting and wiring locations for a direct-fit service repair. What it does:

• Replaces a failed or intermittent control switch that can prevent the appliance from starting or responding.
• Restores reliable electrical contact for buttons, toggles, or selector functions.
• Helps eliminate symptoms like unresponsive controls, inconsistent operation, or power loss to a circuit.
• Matches OEM fit and connection points for straightforward replacement.

• Switch assembly

• Disconnect power (unplug or shut off breaker) before beginning any repair.
• Verify wiring location and take photos before removal to ensure correct reconnection.
• Use appropriate tools and avoid damage to surrounding components or harnesses.

This temperature sensor (thermistor) monitors refrigerator/freezer temperature and helps the control board regulate cooling for stable food storage. It replaces a failing sensor to restore accurate temperature readings and consistent operation. What it does:

• Measures internal air or evaporator temperature so the control board can cycle the compressor and fans correctly
• Can cause incorrect or fluctuating temperatures when failing
• Works with the appliance's control system to help maintain set temperatures

• Disconnect power to the appliance before servicing to avoid shock or damage
• Handle the sensor and wiring harness gently to avoid kinking or breaking the leads
• Test with a multimeter or follow manufacturer diagnostics if you suspect a faulty sensor

A temperature probe that senses appliance temperature and sends readings to the control board so the unit can regulate cooling or heating. Replacing a failed probe helps restore accurate temperature control and steady operation. What it does:

• Detects internal temperature and reports signals to the appliance control for proper temperature regulation.
• A worn or damaged probe can cause the appliance to run constantly, short-cycle, or struggle to maintain set temperatures.
• Can help resolve uneven cooling/heating and temperature-related error codes when replaced.
• Works as part of the appliance's temperature-sensing/control system.

• Disconnect power to the appliance before starting any repair to avoid shock or injury.
• Handle the sensor tip and wiring gently; avoid kinking, crushing, or contaminating the probe element.
• Match the connector, routing, and mounting to the original; secure wiring away from moving parts and extreme heat.
• After installation, restore power and ensure the appliance reaches and maintains expected temperatures.