Parts for Frigidaire FFRG4120SW2: Burner Parts

A mechanical temperature control thermostat that senses refrigerator temperature and cycles the compressor to maintain set temperatures. Restores reliable on/off control for aging or failed temperature regulators. What it does

• Senses internal temperature and opens/closes the cooling circuit to regulate compressor run time
• Can stop short-cycling or continuous running when the original thermostat fails
• Helps recover proper temperature control when fridge or freezer temperature won't stabilize
• Works with mechanical control assemblies that use a capillary sensor bulb

• One temperature control thermostat

• Disconnect power to the appliance before starting any repair
• Handle the thermostat and its capillary sensor carefully; avoid kinking or pinching the tube
• Mount and route the sensor bulb in the same location as the original for accurate sensing
• After installation, verify proper operation by monitoring compressor cycles and interior temperature

The Thermostat is an OEM part for Frigidaire dryers. It is responsible for regulating and maintaining the temperature inside the dryer drum during the drying cycle.

A bad dryer thermostat can be caused by wear and tear over time, electrical issues, or component failure. Signs of a faulty thermostat include the dryer not heating up, overheating, or not shutting off at the appropriate temperature.

Symptoms of a bad dryer thermostat include:

• The dryer not heating 
• Excessive heat inside the dryer drum
• The dryer not shutting off at the desired temperature

Replace your malfunctioning or damaged dryer thermostat with this genuine OEM Frigidaire part to restore your dryer. This Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.
 

The Ignitor is an OEM part for Frigidaire dryers. It is responsible for providing the necessary heat to ignite the gas, allowing the dryer to produce the necessary heat for drying your clothes.

A bad dryer ignitor can be caused by wear and tear over time, damage from mishandling, or electrical issues. Signs of a faulty ignitor include the dryer not heating up, taking longer to dry clothes, or not starting at all.

Symptoms of a bad dryer ignitor include:

• The dryer not heating 
• Clothes taking longer to dry than usual
• The dryer not starting or responding 

Replace your worn-out or damaged dryer ignitor with this genuine OEM Frigidaire part to restore your dryer. This Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.
 

This support is a replacement mounting bracket that holds appliance components securely in place to restore proper alignment and reduce rattling or sagging. Designed to match the original fit and function for a seamless repair. What it does:

• Holds and aligns panels, drawers, or internal components to prevent sagging or misalignment
• Restores secure fitment that can stop rattling, vibration, or movement during operation
• Replaces cracked or broken brackets that cause loose or unstable parts
• Works as a direct-fit replacement when the original support is damaged or missing

• Disconnect power before starting any repair
• Handle small hardware and sharp edges carefully; use appropriate hand tools
• Verify part orientation against the removed piece before fastening
• Keep track of screws/clips and reuse only the correct fasteners

The LP Conversion Kit is an OEM part for Frigidaire gas dryers. It allows the appliance to be converted from using natural gas to liquid propane fuel. The kit includes all necessary components like a new gas valve, pilot light assembly, and installation instructions.

Causes for needing conversion include moving the dryer to a home-only set up for liquid propane tanks, rather than natural gas lines.

Symptoms of an improper gas type include: 

• Yellow, sooty, or unstable burner/pilot flames
• Inconsistent or incomplete drying times  
• Gas smell when the dryer is operating
• Error codes related to gas valve or ignition problems

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.