Parts for Ge DPXH46GA3CC: 05 - Burner Parts

A replacement pan head screw used to fasten appliance panels and components. Its standard #8 coarse thread and 3/8-inch length secure trim, brackets, and small assemblies for stable operation. What it does:

• Fastens panels, brackets, and small parts in household appliances
• Replaces stripped, rusted, or missing #8-18 pan head screws
• Restores secure mounting where vibration or wear caused looseness
• Works with sheet-metal or threaded inserts designed for #8-18 screws

• Disconnect power to the appliance before beginning any repair
• Use the correct #2 Phillips or compatible driver to avoid cam-out
• Thread in straight and tighten until snug; avoid over-tightening to prevent stripping
• Keep small screws away from children and dispose of old fasteners safely

8 - 18 x 0.31

This gas dryer igniter is the glow-bar element that lights the burner so your dryer can produce heat. Replacing a worn, cracked, or non-glowing igniter restores reliable ignition and consistent drying performance.

• Heats and glows to ignite gas at the burner assembly
• Common symptoms: dryer runs but no heat, igniter does not glow, burner won't light
• Visual cracks or a non-heating element indicate failure

• Disconnect power and shut off the gas supply; allow the burner area to cool before service
• Handle by the base only; the igniter element is extremely fragile—do not touch or bump it
• Transfer bracket and wiring from the old part if needed; reuse existing hardware
• Restore gas and power, then the igniter glows and the burner lights properly