Parts for Ge ZX2LY2SS: 01 - Burner Parts

Replace your worn, cracked, or missing range top grate. This cast iron cooking grate sits over the burner to support pots and pans during cooking.

This is a venturi gasket that serves as a replacement for use with gas ranges. The gasket is used on the venturi tubes, which extend from the burner to the control valves. The gaskets provide a seal, so there is not too much air mixing with the gas. If they are not working properly, they could also let the gas out beneath the burner, which would be dangerous.Over time, the gasket material will start to wear down, break, and crumble and will need to be replaced. Additionally, when doing other work, such as installing a new head on the range, it is advisable to change out the gasket at the same time if it appears worn. The replacement for this part is relatively simple.This venturi gasket will work with many models of gas stoves from General Electric. The gasket is a genuine OEM replacement part that has been sourced directly from the manufacturer. The gasket is sold individually. Owners might want to have a couple of replacements on hand.

Fix uneven heating or weak flames on your cooktop with this hex burner. Direct replacement part restores proper flame distribution. Moderate DIY.

Gas manifold for cooktops. Distributes gas from supply line to burner valves. Replace if cracked, leaking, corroded, or damaged during repairs.

This right-side cabinet panel replaces a damaged or missing exterior refrigerator side to restore the appliance's appearance and protect internal components from dust and handling. Designed to match the original fit and finish. What it does:

• Covers and protects the refrigerator's right exterior cabinet area.
• Restores a clean, finished look after dents, scratches, or panel loss.
• Helps prevent dust and contaminants from reaching internal components.
• Eliminates rattles or gaps caused by a loose or missing side panel.

• Disconnect power before servicing to avoid electrical hazard.
• Remove adjacent trim or components as needed to access fasteners.
• Handle edges carefully; replacement panels may have sharp edges.
• Use the original fasteners or equivalent hardware.

Cooktop won't ignite or clicks continuously? This electrode assembly creates the spark needed to light gas burners. Simple DIY fix for ignition issues.

This grill cover handle is used to open and close a grill. If the handle is missing, opening the grill can be difficult and dangerous. Over time, heat from the grill can cause the handle to become cracked or break and fall off. When this happens, the handle should be replaced before using the grill. It is not advised to use a makeshift handle or open the grill with anything other than an OEM handle. Open the grill cover and look underneath to locate the screws for the handle. Remove the broken handle using a screwdriver. Save the screws for installing the new handle. Remove the handle from the packaging and line it up with the predrilled holes on the grill. Make sure the holes align. Install the screws from the backside of the lid and tighten. Close the grill. This grill cover handle is made of durable plastic and is sold individually. It does not come with installation screws. It is designed for use in grills manufactured by General Electric.

This igniter kit lights the gas burners in your oven or cooktop. It creates the electrical spark needed to ignite the gas safely and reliably. Replace it if your burners won't light, take too long to ignite, or only light intermittently.

This igniter kit lights the gas burners in your oven or cooktop. It creates the electrical spark needed to ignite the gas safely and reliably. Replace it if your burners won't light, take too long to ignite, or only light intermittently.

This screw secures internal components on your cooktop or grill. Replace if the original is stripped, corroded, missing, or damaged during service.