Parts for Kenmore 103.6037060 (1036037060, 103 6037060): Burner Section Parts

This Loxit locking retaining nut secures components and terminals on home appliances to keep parts fastened and reduce vibration-related loosening. It's a small but essential hardware piece for reliable mechanical and electrical connections. What it does:

• Secures terminals, studs, or posts to prevent movement and maintain electrical contact
• Holds small assemblies or panels in place to stop rattling or loosening from vibration
• Restores proper fit where a worn or missing nut causes a loose knob, control, or connection
• Helps prevent intermittent electrical contact caused by loose fasteners

• One Loxit locking retaining nut

• Disconnect power to the appliance before starting any repair.
• Verify nut thread and size match the stud before installation; use correct hand tools.
• Tighten securely but avoid over-torquing to prevent stripping or damage.
• Ensure proper seating and inspect wiring for wear.

This replacement screw secures appliance components so panels, brackets, and assemblies stay tight and aligned. Replace stripped or missing hardware to eliminate rattles and keep your unit assembled safely and correctly.

• Fastens panels, brackets, or components to the appliance frame
• Restores a secure fit when the original screw is lost, stripped, or corroded
• Helps prevent vibration noise and movement during operation
• Supports proper alignment of trim and assemblies

• Disconnect power; for gas units, also shut off the gas supply
• Use the correct driver to avoid stripping the head; do not overtighten
• Inspect and address damaged mating threads, clips, or brackets before reinstalling
• Refer to your model's parts diagram to confirm location and quantity

Includes 12 washers.

This replacement screw secures appliance components so panels, brackets, and assemblies stay tight and aligned. Replace stripped or missing hardware to eliminate rattles and keep your unit assembled safely and correctly.

• Fastens panels, brackets, or components to the appliance frame
• Restores a secure fit when the original screw is lost, stripped, or corroded
• Helps prevent vibration noise and movement during operation
• Supports proper alignment of trim and assemblies

• Disconnect power; for gas units, also shut off the gas supply
• Use the correct driver to avoid stripping the head; do not overtighten
• Inspect and address damaged mating threads, clips, or brackets before reinstalling
• Refer to your model's parts diagram to confirm location and quantity

This cover screw secures appliance panels and covers, keeping components protected and aligned. Replace missing, stripped, or corroded screws to restore a tight fit and help eliminate rattles, gaps, or panels that won't stay in place.

• Attaches an access cover or panel to the appliance frame
• Helps maintain proper alignment to protect internal components
• Replaces missing, stripped, or rusted hardware
• Typical signs: loose or rattling panel, cover won't stay secure, damaged or rounded screw head

• Disconnect power before servicing
• Support the panel while removing and installing screws to prevent misalignment
• Start threads by hand to avoid cross-threading; do not overtighten
• Use a matching driver bit to avoid damaging the screw head