Parts for Kenmore 267.1532311 (2671532311, 267 1532311): Cabinet (2) Parts

Size: 8 - 18 ab.

A push-on speed nut that secures panels, trim, or lightweight components to studs and shafts, restoring a tight, rattle-free fit. Ideal when the original retaining nut is damaged or missing. What it does

• Climbs and locks onto a threaded stud or shaft to hold panels and assemblies in place
• Prevents loosening and vibration that can cause rattles or misalignment
• Common replacement when the original nut is stripped, cracked, or no longer grips

• Disconnect power and water (if applicable) before servicing the appliance
• Press the nut firmly onto the stud or shaft until fully seated; use pliers for tight fits if needed
• Replace any damaged mating hardware for a secure repair

This is a #8-18 by 5/8-inch Torq II-head screw used to secure appliance panels and components. It provides a reliable fastener option when replacing stripped or missing screws to restore proper fit and reduce vibration or rattling. What it does:

• Secures trim, panels, brackets or small components to appliance frames
• Restores proper alignment and reduces noise from loose parts
• Replaces worn, stripped, or missing fasteners to prevent further damage
• Compatible where an 8-18 thread and 5/8" length with a Torq II-style head are specified

• One screw

• Use the correct Torq II driver bit to avoid cam-out or head damage
• Tighten until snug; avoid over-tightening which can strip threads or crack plastic
• If replacing rusted or stripped screws, inspect mating threads and replace as needed
• Disconnect power and follow appliance safety instructions before servicing

This is a replacement 8-32 trilobular hex screw used to fasten appliance panels and components. It restores secure mounting and helps eliminate loose parts or rattling caused by missing or worn fasteners. What it does:

• Secures panels, brackets, or components in place using an 8-32 trilobular thread form
• Helps prevent vibration, rattling, and loose connections when fasteners are missing or stripped
• Designed to match OEM thread style for proper engagement and retention
• Used wherever a small hex-head machine screw is required for assembly

• Use the correct driver/socket to avoid rounding the hex head
• Tighten to snug fit; avoid over-torquing which can strip threads or damage parts
• If replacing a stripped hole, inspect mating threads and consider a thread repair or alternate fastening method
• Disconnect power to the appliance before accessing internal components to reduce risk of shock or injury