Parts for Lg WD-3243RHD: Cabinet Assembly Parts

This Leg Adjusting Wrench is a simple tool used to turn and secure appliance leveling legs so washers and dryers sit flat and operate quietly. It makes adjusting legs faster and helps reduce rocking and vibration. What it does:

• Fits over standard appliance leveling legs to raise or lower each corner
• Helps stabilize machines to prevent rocking and uneven operation
• Reduces vibration and noise caused by unlevel appliances
• Useful when installing, moving, or re-leveling washers and dryers

• Turn legs slowly and adjust one corner at a time until the appliance sits level.
• Unplug the appliance (and shut off gas supply for gas dryers) before performing major moves or checks.
• Use caution to avoid pinching fingers when lowering legs; keep hands clear of pinch points.
• Check for damaged feet or mounting hardware and replace as needed.

This base bracket mounts to the washer's lower frame to hold associated components securely in place. By keeping parts properly anchored, it helps maintain alignment and stability during operation to minimize vibration and noise.

• Attaches to the washer base and provides a mounting point for designated hardware
• Helps keep assemblies from shifting during agitation and spin
• Supports smooth, quieter operation by reducing vibration and rattling
• Common signs of failure include a bent or cracked bracket, loose/misaligned parts, or unusual noises from the base area

• Disconnect power and water supply before servicing; move the appliance for safe access
• Carefully tip or lay the washer back on protective padding; use a helper for stability
• Note the bracket's orientation and reuse existing mounting hardware as applicable
• Tighten fasteners securely and verify nearby parts have proper clearance before test run

The Water Level Pressure Switch is an OEM part for LG washing machines. It monitors the water level inside the washer and signals the control board to stop filling when the desired level is reached, ensuring the correct amount of water is used for each cycle.

Causes of a bad water level pressure switch can include electrical malfunctions, damage to the pressure sensor, or blockages in the air tube connected to the switch.

Symptoms of a bad water level pressure switch include:

• The washer overfilling or underfilling with water
• Inconsistent water levels during different cycles
• Error codes related to water levels
• The washer not progressing through cycles properly

This OEM LG part is also compatible with Sears/Kenmore models.