Parts for Ge AJCH08ACM1: 01 - Cabinet & Components Parts

Replacement drip pan for air conditioner units. Installs beneath the evaporator coil to collect condensation. Needed when original pan is cracked or corroded.

Stud bolt for air conditioner chassis and component mounting. Replace if threaded portion is stripped, bent, or broken. Secures internal parts to frame.

Fix a non-cooling air conditioner or weak airflow with this fan motor assembly. Common solution when the unit runs but doesn't cool properly.

Fix loud rattling or vibration from your AC's outdoor fan. This condenser fan blade restores proper airflow when damaged or cracked. Easy 15-minute DIY fix.

Rubber cushion that mounts between the air conditioner motor and housing to reduce vibration and noise. Replace if cracked, compressed, or missing.

Replacement mounting nut for air conditioner units. Secures panels and components during installation. Needed when original nut is stripped, lost, or damaged.

Weak airflow or no cooling from your air conditioner? This blower wheel circulates air over the evaporator coils. Moderate DIY repair in 30-45 minutes.

Replacement front panel assembly for air conditioner units. Restores the exterior appearance when the original panel is cracked, broken, or damaged.

Replacement horizontal louver for air conditioners. Directs airflow up and down. Needed when original louver is cracked, broken, or missing.

Replacement notch spring for air conditioners. Secures internal components. Order if original spring is broken, missing, or has lost tension.

Special mounting screw for air conditioner assembly. Replace if screw is stripped, missing, or damaged during maintenance or installation work.

Color: beige. It measures about 16 inches wide by 10 inches high.

This wire fixing band is a small retainer clamp that secures wiring harnesses and individual wires to appliance chassis to prevent rubbing, pinching, or accidental disconnection. It helps protect wiring from damage and reduces electrical faults. What it does:

• Holds wiring harnesses and loose wires in place to prevent contact with hot or moving parts
• Reduces wear from vibration and movement that can cause frayed insulation or shorts
• Helps maintain safe routing of wires to avoid pinch points and strain on connectors
• Commonly used where a simple clipped band or strap is needed to fasten wires to sheet metal

• Inspect surrounding wiring and connectors before installation; replace damaged wires or insulation
• Secure the band to the designated chassis hole or stud without over-tightening to avoid crushing wires
• Disconnect power before accessing wiring and follow all appliance safety procedures