Parts for Ge AJCH10DCBW2: 01 - Cabinet & Components Parts

Replacement drip pan for air conditioners. Installs beneath the evaporator coil to collect condensation. Order if your original pan is cracked or missing.

Rubber cushion that mounts between the air conditioner motor and housing to reduce vibration and noise. Replace if cracked, compressed, or missing.

Replace the special mounting nut for your room air conditioner. Secures components and panels. Order a new nut if the original is stripped or missing.

Fix weak airflow or no cooling with this air conditioner indoor fan motor. Direct replacement part restores proper air circulation. Moderate DIY repair.

Replace a stripped, corroded, or missing special nut in your air conditioner. Secures internal components and panels for proper assembly and stability.

Replaces a cracked, worn, or damaged front panel bezel on your air conditioner. Restores appearance and provides secure mounting for controls.

Replacement horizontal louver for air conditioners. Directs airflow up and down. Needed when original louver is cracked, broken, or missing.

Replacement notch spring for air conditioners. Secures internal components. Order if original spring is broken, missing, or has lost tension.

Special mounting screw for air conditioner assembly. Replace if screw is stripped, missing, or damaged during maintenance or installation work.

Replace your air conditioner filter to maintain clean air circulation and efficient cooling. Change when dirty or damaged. Confirm fit with your model number.

Motor seal for air conditioners. Replace if you notice air leaks, reduced cooling efficiency, or moisture around the motor. Verify fit with your model number.

This motor angle clip is a small mounting bracket that secures the motor at the correct angle for stable operation and alignment. It helps keep drive components positioned so the appliance runs smoothly. What it does:

• Secures the motor housing to the appliance frame to maintain proper alignment
• Prevents motor shifting that can cause rubbing, noise, or belt misalignment
• Supports consistent drive-line angle for reliable performance
• Used when a bent, broken, or missing motor bracket causes instability or unusual vibration

• One motor angle clip / mounting bracket

• Designed to fasten with existing screws or hardware; verify fastener type before installation
• Turn off and disconnect power before attempting any repair
• Handle bracket and motor carefully to avoid damage to wires or adjacent components

Molded air vent louver grille for air conditioners. Restores proper airflow routing and finished appearance. Replaces cracked, broken, or missing vent.

Special screw for air conditioner assembly. Replaces lost, stripped, or damaged screws during installation or repair. Secures components properly.

Replace a cracked or broken cabinet support plate on your air conditioner. Mounts inside the unit to provide structural support for secure installation.

Replacement mounting bracket for air conditioner cabinets. Secures unit to window frame or wall. Order new bracket if original is bent, cracked, or missing.

Replace your air conditioner's front panel assembly if the original is cracked, broken, or damaged. This cosmetic panel covers the front of the unit.