Parts for Ge AJEH12DCAM1: 01 - Cabinet Components Parts

Replacement stud bolt for air conditioner units. Secures internal components and housing panels. Order a new bolt if yours is stripped, broken, or missing.

Fix your air conditioner that won't cool or runs constantly. This condenser fan motor restores proper cooling. Common repair for no cooling issues.

Replacement outdoor motor mount for air conditioners. Secures the fan motor to the unit frame. Order a new mount if yours is cracked, broken, or missing.

Replacement wire holder for air conditioners. Secures and organizes internal wiring. Order a new holder if yours is cracked, broken, or missing.

Fix weak airflow or no cooling in your air conditioner with this indoor fan motor. Direct replacement part fits multiple models. Moderate DIY repair.

Rubber cushion that mounts between the air conditioner motor and housing to reduce vibration and noise. Replace if cracked, compressed, or missing.

Replacement mounting nut for air conditioner units. Secures panels and components during installation. Needed when original nut is stripped, lost, or damaged.

Replacement front panel assembly for air conditioner units. Restores the exterior appearance when the original panel is cracked, broken, or damaged.

Replacement horizontal louver for air conditioners. Directs airflow up and down. Needed when original louver is cracked, broken, or missing.

Replacement notch spring for air conditioners. Secures internal components. Order if original spring is broken, missing, or has lost tension.

Replace your air conditioner filter to maintain clean air circulation and efficient cooling. Change when dirty or damaged. Confirm fit with your model number.

This EVA pipe cushion is a foam sleeve that cushions and insulates a refrigerator's refrigerant tubing to reduce vibration and prevent metal-on-metal contact. It protects lines and helps cut down on noise and wear. What it does:

• Cushions refrigerant/evaporator tubing to stop rubbing and chafing
• Dampens vibration that can cause noise from the line set
• Provides basic insulation to reduce minor heat transfer at contact points
• Helps prevent damage from tube contact with cabinet or mounts

• One EVA foam pipe cushion

• Disconnect power to the appliance before servicing
• Slide or wrap the foam sleeve around the tubing at the contact point; trim to fit if needed
• Ensure the sleeve does not cover sensors, valves, or service access points
• Replace any damaged or brittle cushions to maintain protection

AC won't stay running? This thermal overload protector safeguards the motor and compressor by opening when temperature or current rises too high.

This protector heater is a small heating element used with the overload/thermal protector in the motor or compressor circuit. It provides calibrated warmth so the protector trips correctly under heavy load, helping prevent overheating and protecting the unit. What it does:

• Works with the overload/thermal protector to ensure proper trip timing
• Helps prevent overheating and potential damage to the motor/compressor
• Common signs include repeated clicking near the compressor area or frequent overload trips

• 1 protector heater

• Disconnect power and safely discharge the run capacitor before servicing
• Photograph or label wiring and component orientation for accurate reassembly
• Install in the same position/orientation as the original with secure, insulated connections and proper wire routing
• Inspect the overload, start device, and terminals; replace any burnt or loose connectors to prevent repeat failures

Replacement use and care manual for your air conditioner. Provides operating instructions, maintenance guidelines, and care information if original manual is lost or damaged.