Parts for Ge AJES10DSBW1: 01 - Cabinet & Components Parts

Replacement drip pan for air conditioners. Installs beneath the evaporator coil to collect condensation. Needed when original pan is cracked or corroded.

Replacement condenser shroud for air conditioners. Protects coils and directs airflow. Order a new shroud if yours is cracked, broken, or missing.

Secures and shields the condenser assembly in room air conditioners. Replace if your original plate is cracked, damaged, or missing to restore stability.

If your air conditioner isn't cooling or the fan won't run, the indoor fan motor may have failed. This motor circulates air through the evaporator coils.

Rubber cushion that mounts between the air conditioner motor and chassis to reduce vibration. Replace if cracked, hardened, or missing.

Replace a stripped, corroded, or missing special nut in your air conditioner. Secures internal components and panels for proper assembly and stability.

Plastic holder that secures and positions the directional louvers in your air conditioner. Replace if cracked, broken, or missing to restore louver function.

Replacement notch spring for air conditioner units. This small structural component secures internal parts. Order a new spring if yours is broken, missing, or damaged.

Special mounting screw for air conditioner assembly. Replace if screw is stripped, missing, or damaged during maintenance or installation work.

Replace your air conditioner filter to maintain clean air circulation and efficient cooling. Change when dirty or damaged. Confirm fit with your model number.

Louver holder for air conditioner front panel. Secures and supports louvers in place. Replace if cracked, broken, or missing to restore proper fit.

This EVA pipe cushion is a foam sleeve that cushions and insulates a refrigerator's refrigerant tubing to reduce vibration and prevent metal-on-metal contact. It protects lines and helps cut down on noise and wear. What it does:

• Cushions refrigerant/evaporator tubing to stop rubbing and chafing
• Dampens vibration that can cause noise from the line set
• Provides basic insulation to reduce minor heat transfer at contact points
• Helps prevent damage from tube contact with cabinet or mounts

• One EVA foam pipe cushion

• Disconnect power to the appliance before servicing
• Slide or wrap the foam sleeve around the tubing at the contact point; trim to fit if needed
• Ensure the sleeve does not cover sensors, valves, or service access points
• Replace any damaged or brittle cushions to maintain protection

AC won't stay running? This thermal overload protector safeguards the motor and compressor by opening when temperature or current rises too high.

This protector heater is a small heating element used with the overload/thermal protector in the motor or compressor circuit. It provides calibrated warmth so the protector trips correctly under heavy load, helping prevent overheating and protecting the unit. What it does:

• Works with the overload/thermal protector to ensure proper trip timing
• Helps prevent overheating and potential damage to the motor/compressor
• Common signs include repeated clicking near the compressor area or frequent overload trips

• 1 protector heater

• Disconnect power and safely discharge the run capacitor before servicing
• Photograph or label wiring and component orientation for accurate reassembly
• Install in the same position/orientation as the original with secure, insulated connections and proper wire routing
• Inspect the overload, start device, and terminals; replace any burnt or loose connectors to prevent repeat failures

Louver base support plate for air conditioners. Mounts behind the directional louvers to provide structural support. Replace if cracked or broken.

Molded air vent louver grille for air conditioners. Restores proper airflow routing and finished appearance. Replaces cracked, broken, or missing vent.

Special screw for air conditioner assembly. Replaces lost, stripped, or damaged screws during installation or repair. Secures components properly.

Replace a cracked or broken cabinet support plate on your air conditioner. Mounts inside the unit to provide structural support for secure installation.

Replacement mounting bracket for air conditioner cabinets. Secures unit to window frame or wall. Order new bracket if original is bent, cracked, or missing.