Parts for Ge AJES12DCBM2: 01 - Cabinet & Components Parts

Replacement drip pan for air conditioners. Installs beneath the evaporator coil to collect condensation. Order if your original pan is cracked or missing.

Replacement stud bolt for air conditioner units. Secures internal components and housing panels. Order a new bolt if yours is stripped, broken, or missing.

Rubber cushion that mounts between the air conditioner motor and housing to reduce vibration and noise. Replace if cracked, compressed, or missing.

Replace your air conditioner's condenser shroud if cracked, broken, or missing. This protective housing cover installs over the condenser unit exterior.

Replace a faulty air conditioner heating element if your unit won't heat in winter mode. This part restores proper heating function in heat pump systems.

Fix your air conditioner when the indoor fan won't spin or runs loudly. This fan motor circulates air through the evaporator. Moderate DIY repair.

Replace a stripped, corroded, or missing special nut in your air conditioner. Secures internal components and panels for proper assembly and stability.

Plastic holder that secures and positions the directional louvers in your air conditioner. Replace if cracked, broken, or missing to restore louver function.

Replacement notch spring for air conditioner units. This small structural component secures internal parts. Order a new spring if yours is broken, missing, or damaged.

Special mounting screw for air conditioner assembly. Replace if screw is stripped, missing, or damaged during maintenance or installation work.

Replace your air conditioner filter to maintain clean air circulation and efficient cooling. Change when dirty or damaged. Confirm fit with your model number.

Motor seal for air conditioners. Replace if you notice air leaks, reduced cooling efficiency, or moisture around the motor. Verify fit with your model number.

Louver holder for air conditioner front panel. Secures and supports louvers in place. Replace if cracked, broken, or missing to restore proper fit.

This motor angle clip is a small mounting bracket that secures the motor at the correct angle for stable operation and alignment. It helps keep drive components positioned so the appliance runs smoothly. What it does:

• Secures the motor housing to the appliance frame to maintain proper alignment
• Prevents motor shifting that can cause rubbing, noise, or belt misalignment
• Supports consistent drive-line angle for reliable performance
• Used when a bent, broken, or missing motor bracket causes instability or unusual vibration

• One motor angle clip / mounting bracket

• Designed to fasten with existing screws or hardware; verify fastener type before installation
• Turn off and disconnect power before attempting any repair
• Handle bracket and motor carefully to avoid damage to wires or adjacent components

AC won't stay running? This thermal overload protector safeguards the motor and compressor by opening when temperature or current rises too high.

This high limit thermostat is a safety device that monitors the heating element temperature in a room air conditioner with a built-in heater. It shuts off the heater if the temperature exceeds a safe threshold, preventing overheating and potential fire hazards. Replace this thermostat if the heater stops working, cycles erratically, or if the unit shuts off unexpectedly during heating mode.

Molded air vent louver grille for air conditioners. Restores proper airflow routing and finished appearance. Replaces cracked, broken, or missing vent.

Special screw for air conditioner assembly. Replaces lost, stripped, or damaged screws during installation or repair. Secures components properly.

Replace a cracked or broken cabinet support plate on your air conditioner. Mounts inside the unit to provide structural support for secure installation.

Replacement mounting bracket for air conditioner cabinets. Secures unit to window frame or wall. Order new bracket if original is bent, cracked, or missing.