Parts for Whirlpool 7KFCC150S0: 04 - Cabinet And Control Parts

Size: 8 x 1/2 ab.

This part has been discontinued and is no longer available

Color: Black. Instruction sheet included.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

This replacement control knob fits over the control shaft to select cycles, temperatures, or functions. It restores a secure grip and clear pointer when the original knob is cracked, stripped, or missing, returning smooth, accurate adjustments.

• Mounts to the control shaft to change and indicate settings
• Replaces knobs that are cracked, wobble, spin freely, or fall off
• Helps with symptoms like difficulty turning the control or inconsistent selections
• Restores a clean, finished look to the control panel

• Disconnect power (and gas, if applicable) before servicing.
• Pull the old knob straight off the shaft—do not twist the control stem.
• Align the D/flat/keyed insert with the shaft and press the new knob on until fully seated—do not force.
• If your original used a spring clip or set screw, transfer/adjust as needed.

The On/Off Rotary Switch Kit is an OEM part for Whirlpool trash compactors. This kit includes the rotary switch and necessary components to control the power and operation of the trash compactor, allowing users to turn the unit on and off easily.

Causes of a bad rotary switch can include electrical wear and tear, damage from repeated use, or issues with the internal contacts. Over time, these factors can lead to the switch becoming unresponsive or failing to control the compactor properly.

Symptoms of a bad rotary switch include:

• The trash compactor not turning on or off
• Intermittent operation of the compactor
• The switch feeling loose or unresponsive
• Electrical sparking or unusual noises from the switch area

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This switch nut secures a rotary control or switch to the appliance's front panel. Replacing a stripped or missing nut keeps the control stable so the knob turns smoothly and the shaft stays properly aligned.

• Clamps the switch/control to the panel to prevent movement or rotation
• Helps maintain correct knob alignment with dial markings
• Common symptoms: loose or wobbly knob, switch rotates in the panel, missing/damaged nut
• Often needed after service if the original nut is stripped or lost

• Disconnect electrical power before servicing
• Remove the knob and any decorative escutcheon; thread the new nut onto the switch bushing from the front of the panel
• Support the switch from behind while tightening; do not overtighten to avoid panel or switch damage
• Restore power and test control operation