Parts for Bosch B22FT80SNS/01: Cabinet Parts

This filter reduces contaminants to provide clean, fresh tasting water. Fits select Bosch freestanding french door refrigerators. Water filters should be changed every 6 months or when the appliance indicates it needs to be changed. This replaces part numbers: BORPLFTR20, 00798470, PS10058838. Filter Media: Coconut Carbon Block. Operating Pressure: 30-120 psi. Operating Temperature: 33-100 °F. Meets NSF Standard: 42. Approved for WQA Gold Seal.

Replacement mounting screw for refrigerator panels, brackets, and trim assemblies. Needed when original fastener is missing, stripped, or damaged.

Replacement roller set for refrigerators. Installs on the base to allow smooth movement and mobility. Needed when rollers are cracked or broken.

This hinge secures and guides a refrigerator or appliance door for smooth opening and reliable closure, restoring proper alignment and preventing sagging or uneven gaps. Designed to match the original mounting points for a direct replacement. What it does

• Supports and pivots the door so it opens and closes smoothly.
• Restores proper door alignment to stop sagging or rubbing.
• Helps maintain a tight door seal to reduce cold air loss.
• Replaces worn or damaged hinge hardware that causes noisy or uneven movement.

• One hinge assembly

• Disconnect power and remove contents from the door before starting work.
• Support the door while removing the old hinge to prevent dropping or damage.
• Reuse original fasteners when possible; tighten screws securely but avoid over-torquing.

Replacement mounting screw for refrigerator assembly. Used to secure internal components and panels. Order this part if your original screw is stripped, missing, or damaged during repairs.

This spacer is a small mounting/support piece used to position and stabilize appliance panels and components, helping maintain correct alignment and reduce vibration. It fits into specific mounting points to preserve proper spacing between parts. What it does:

• Provides a stable gap between panels or components to ensure proper alignment
• Supports and positions parts during assembly to prevent rubbing or binding
• Helps reduce vibration-related noise by maintaining consistent spacing
• Can correct minor panel misalignment that causes uneven gaps or rattling

• Disconnect power and water before starting any repair
• Access may require removing panels or trim; keep fasteners organized
• Install in the original mounting location and hand-start fasteners before final tightening
• Do not force parts; verify fit and alignment before restoring power