Parts for Bosch HBL5751UCC/01: Cabinet Parts

This outer housing replaces a damaged or cracked enclosure that protects a dishwasher's internal components and helps maintain proper alignment and support. Restores structural integrity and helps reduce noise and vibration. What it does:

• Covers and protects internal components from moisture, debris, and accidental contact
• Provides mounting surfaces and alignment for pumps, motors, and other assemblies
• Helps reduce vibration and rattling caused by loose or damaged panels
• Visible damage or large cracks can allow leaks, excessive noise, or poor component alignment

• Disconnect power and water supply before beginning any repair
• Removal typically requires taking off outer panels and disconnecting attached components; follow manufacturer instructions
• Inspect surrounding seals, gaskets, and mounting hardware during reassembly and replace if worn

This trim plate covers and protects the appliance control area while restoring a finished appearance to the front panel. It helps hide fasteners and worn edges for a clean, factory look after repairs. What it does:

• Replaces a damaged, scratched, or missing control-area trim to improve appearance
• Conceals screws and edges around the control panel for a finished look
• Helps prevent dirt and moisture from collecting in the control-panel seam
• Matches the original exterior finish and mounting points for easy fit

• Designed to mount using the appliance's existing screws and clips; screw locations before tightening
• Remove power to the appliance before beginning work to avoid electrical hazard
• Handle edges carefully to avoid scratching the finish during installation
• If trim does not align, do not force; part number and fit before drilling or modifying

This connection piece is a replacement hose connector that joins appliance water lines to ensure a secure, leak-free connection. It restores proper water flow and helps prevent drips at the junction. What it does:

• Connects inlet or drain hoses to the appliance plumbing to maintain proper flow
• Seals hose junctions to reduce or stop leaks caused by worn or damaged connectors
• Stabilizes hose alignment to prevent kinking and unpredictable flow
• Commonly replaced when leaks, loose hose fit, or water pooling occur

• One connection piece

• Turn off power and shut off the water supply before replacing the connector
• Verify correct orientation and seating of any gaskets or O-rings; replace seals if damaged
• Hand-tighten fittings, then snug with appropriate tools—do not overtighten

A replacement trim plate that restores the finished look and edge protection of the appliance front. Replaces a worn, dented, or scratched trim to improve appearance and help keep adjacent panels aligned. What it does

• Covers and protects the exposed edge of the appliance front for a clean, finished appearance
• Helps keep control panels and door edges aligned and properly seated
• Replaces a bent, scratched, or otherwise damaged trim that affects cosmetics
• Reduces gaps where dirt and moisture can collect along the appliance edge

• Remove power to the appliance before starting any service to avoid shock or injury
• Installation typically requires removing adjacent trim or the appliance door/panel; use appropriate hand tools
• Keep fasteners and clips organized—verify orientation before tightening

The Screw is an OEM part for Bosch microwave ovens. It is a component that secures the outer casing and front paneling of the microwave. The screw is designed to withstand repeated heating and cooling cycles without loosening or degrading. 

Symptoms of bad screw include:

- The front panel or outer casing becoming loose, detached, or misaligned
- Gaps appearing in the seams or joints of the microwave structure
- The door not sealing properly leading to leaks

Over many uses of the microwave, screws can wear down or strip out from over-tightening during repairs or installations. It is important to replace worn screws to ensure the microwave maintains an intact structure.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.