Parts for Electrolux E24WL50QS1: Cabinet Parts

Upper door hinge supports and aligns your wine cooler door. Replace if door sags, rubs, or won't seal properly. Confirm fit with your model number.

A small metal pin used to secure moving parts like pivots or shafts so doors, drawers, or internal assemblies stay aligned and operate smoothly. Replaces worn or damaged pins to stop excessive play and noisy movement. What it does:

• Secures a pivot or shaft so the linked component rotates or slides on a fixed axis
• Restores proper alignment when a worn pin causes wobble or uneven operation
• Helps stop rattling, binding, or misalignment of the attached part
• Works as the mechanical fastener inside hinge, roller, or linkage assemblies

• Disconnect power or unplug the appliance before servicing
• Keep track of orientation and any washers or clips during removal
• Use appropriate hand tools and secure small parts to avoid loss

This replacement cable tie secures appliance wiring and harnesses to keep wires routed and stable, helping prevent rubbing, pinching, and noise from loose wiring. Simple, low-cost fix when harness clips or ties have failed. What it does:

• Holds wiring harnesses and loose wires in place to reduce chafing and noise
• Prevents harness sagging that can cause intermittent connections or wear
• Keeps wires routed away from moving parts and hot surfaces
• Works wherever a single-use plastic tie is needed for fastening

• Always disconnect power at the breaker or unplug the appliance before working on wiring
• Route the harness as shown in the service diagram; cinch the tie snug but do not over-tighten
• Trim excess tie tail flush and inspect for secure fit; replace if damaged
• Cable ties are single-use; replace with a matching tie if removal is required

This slide is a replacement drawer slide that restores smooth, supported movement for a refrigerator drawer or shelf. It helps drawers glide properly and stay aligned for reliable access to stored items. What it does:

• Replaces a worn or broken drawer slide so the drawer opens and closes smoothly
• Prevents drawers from falling, binding, or coming off their track
• Restores proper alignment and support for loaded drawers
• Reduces noise and uneven movement caused by a damaged slide

• One replacement drawer slide

• Install by removing the drawer and sliding the old piece out, then align and secure the new slide per the appliance's rail pattern
• Keep screws and hardware from the old slide if compatible; replace fasteners only with approved parts
• Wear gloves to avoid sharp sheet-metal edges and disconnect power if working near controls or lighting
• If the drawer still binds after replacing the slide, verify rail alignment and inspect the mating track for damage

Ice maker not turning on or off? This switch controls power to your ice maker unit. A common fix when your appliance won't respond to controls.

Mounting screw secures interior shelves, bins, door components, or trim in refrigerators and freezers. Replace stripped, corroded, or missing screws.