Parts for Electrolux EI24BC10QS1: Cabinet Parts

The Air Filter is an OEM part for Frigidaire refrigerators designed to enhance the air quality inside the refrigerator, ensuring that food stays fresh and odor-free.

The Air Filter helps to remove unwanted odors and impurities from the refrigerator's circulating air. It absorbs and neutralizes common food odors, keeping your fridge smelling clean and pleasant. The activated carbon filter is 7 times more effective than baking soda at removing odors. 

For best results, change filter every 6 months. 
Color: Black. 
Measures about 7 inches wide by 5 inches deep. 

Symptoms of a bad air filter include:

• Lingering food odors inside the refrigerator
• Increased presence of stale or unpleasant smells
• Decreased effectiveness in eliminating odors

Replace your Air Filter with this genuine part to ensure a clean and fresh-smelling refrigerator. This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Front grille panel for wine and beverage coolers. Replaces damaged, cracked, or discolored grilles. Installs on the front for a finished look.

Upper door hinge supports and aligns your wine cooler door. Replace if door sags, rubs, or won't seal properly. Confirm fit with your model number.

A small metal pin used to secure moving parts like pivots or shafts so doors, drawers, or internal assemblies stay aligned and operate smoothly. Replaces worn or damaged pins to stop excessive play and noisy movement. What it does:

• Secures a pivot or shaft so the linked component rotates or slides on a fixed axis
• Restores proper alignment when a worn pin causes wobble or uneven operation
• Helps stop rattling, binding, or misalignment of the attached part
• Works as the mechanical fastener inside hinge, roller, or linkage assemblies

• Disconnect power or unplug the appliance before servicing
• Keep track of orientation and any washers or clips during removal
• Use appropriate hand tools and secure small parts to avoid loss

This replacement cable tie secures appliance wiring and harnesses to keep wires routed and stable, helping prevent rubbing, pinching, and noise from loose wiring. Simple, low-cost fix when harness clips or ties have failed. What it does:

• Holds wiring harnesses and loose wires in place to reduce chafing and noise
• Prevents harness sagging that can cause intermittent connections or wear
• Keeps wires routed away from moving parts and hot surfaces
• Works wherever a single-use plastic tie is needed for fastening

• Always disconnect power at the breaker or unplug the appliance before working on wiring
• Route the harness as shown in the service diagram; cinch the tie snug but do not over-tighten
• Trim excess tie tail flush and inspect for secure fit; replace if damaged
• Cable ties are single-use; replace with a matching tie if removal is required

The Air Filter is an OEM part for Frigidaire refrigerators designed to enhance the air quality inside the refrigerator, ensuring that food stays fresh and odor-free.

The Air Filter helps to remove unwanted odors and impurities from the refrigerator's circulating air. It absorbs and neutralizes common food odors, keeping your fridge smelling clean and pleasant. The activated carbon filter is 7 times more effective than baking soda at removing odors. 

For best results, change filter every 6 months. 
Color: Black. 
Measures about 7 inches wide by 5 inches deep. 

Symptoms of a bad air filter include:

• Lingering food odors inside the refrigerator
• Increased presence of stale or unpleasant smells
• Decreased effectiveness in eliminating odors

Replace your Air Filter with this genuine part to ensure a clean and fresh-smelling refrigerator. This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Ice maker not turning on or off? This switch controls power to your ice maker unit. A common fix when your appliance won't respond to controls.

This factory screw secures interior or door components in your refrigerator so they stay tight and aligned. Replace missing, stripped, or corroded hardware to eliminate looseness and prevent parts from shifting or rattling during use.

• Fastens brackets, trim, rails, bins, or handles to the cabinet or door
• Restores a secure fit when the original screw is lost, damaged, or rusted
• Helps correct looseness, vibration, and rattling from unsecured parts
• Common symptoms: loose or wobbling handle/trim, misaligned parts, missing hardware

• Disconnect power to the appliance before servicing; turn off water if working near dispenser/ice areas
• Match to the original hardware and install in the same location; reuse any washers/spacers
• Start threads by hand to prevent cross-threading; use the correct driver bit
• Tighten snugly—do not overtighten to avoid stripping threads or cracking plastic