Parts for Ge DCVH480EK0WW: 03 - Cabinet Parts

This is a small M4 x L8 screw used to secure the back panel cover on the washer. It holds the rear access panel firmly in place, keeping internal components protected and enclosed. Replace this screw if it is stripped, missing, or corroded, which can cause the back panel to become loose or rattle during operation.

This is a hinge-header screw used to secure door hinge assemblies—provides the correct fit and thread size for a tight, stable hinge connection to keep doors aligned and operating smoothly. What it does:

• Secures the hinge header to the appliance chassis or door hinge assembly
• Restores proper hinge alignment to eliminate door sag or uneven closing
• Prevents looseness that can cause noise, rubbing, or misalignment
• Matches M5 thread and 12mm length for the intended hinge mounting point

• Support the door or hinge assembly before removing or installing the screw to avoid dropping or damaging the door
• Use the correct-sized driver to avoid stripping the head; tighten snugly but avoid over-torquing
• Disconnect power or follow appliance-specific safety procedures if removing panels near electrical components

Seals and cushions the dryer drum edge to prevent fabric catching, reduce noise, and direct airflow. Replace when worn or torn. Verify fit with model number.

Felt cushioning strip that mounts to dryer bracket or cabinet to reduce metal contact and quiet vibration. Replace if worn, compressed, or missing.

Drum bearing assembly enables smooth drum rotation in your dryer. Replace if you hear squealing or grinding noises during cycles. Confirm fit with your model.

Dryer bearing cover protects the drum support bearing from lint and debris. Replace if cracked, worn, or causing squeaking noises. Verify fit with your model.

This housing heater secures and protects the heater element used in the refrigerator defrost system, helping prevent frost buildup and maintain proper cooling performance. It provides a durable mounting for the heater where needed. What it does

• Holds and shields the defrost heater element so it heats evenly across the evaporator
• Helps prevent ice buildup that can block airflow or reduce cooling efficiency
• Common symptom: visible frost or ice accumulation on the evaporator or reduced cooling performance
• Common symptom: dripping or pooling water from uneven defrosting

• One housing heater assembly

• Disconnect power to the appliance before starting any repair
• Remove the evaporator cover and related panels to access the heater housing; follow the OEM service manual
• Handle the heater element and connections carefully to avoid damage

Secures the terminal block to your dryer's electrical assembly. Replace if cracked, broken, or missing to properly mount the terminal connection block.

Dryer not heating or producing insufficient heat? This heating element assembly distributes heat throughout the drum. Requires front panel removal to install.

If your dryer has exposed electrical connections or won't power on safely, the terminal block cover may be damaged. This protective cover installs quickly.

Exhaust duct assembly routes hot air out of your dryer and shields internal components. Replace if cracked, damaged, or causing poor airflow.

Adjustable leveling leg threads into your dryer base to support and stabilize the unit. Replace if broken, cracked, or missing to level on uneven floors.

This rubber mounting pad cushions and isolates appliance components to reduce vibration and noise, helping parts sit securely and run quieter. A simple replacement for worn or damaged pads that lets the appliance operate more smoothly. What it does:

• Acts as a vibration damper to reduce noise and movement during operation
• Provides a stable cushion between metal parts or between appliance and mounting surface
• Helps prevent rubbing, rattling or premature wear caused by metal-on-metal contact
• Commonly replaced when pads are cracked, compressed, missing or deteriorated

• Disconnect power and, if applicable, water supply before accessing internal components
• Inspect mounting area and clean surfaces before installing the new pad
• Press or fit the pad into place; no special tools typically required
• If multiple pads on the same assembly are worn, replace them together for even support