Parts for Ge DPSR483GA2AA: 03 - Cabinet Parts

E-coat

This adjustable gray foot supports and levels your dryer, allowing you to compensate for uneven floors. It screws into the dryer's base and can be raised or lowered to ensure the appliance sits level and stable. Replace this part if your dryer rocks, vibrates excessively, or appears tilted.

Replacement screw that secures dryer panels, trims, and internal components. Needed when original fasteners are missing, stripped, or corroded.

This exterior side panel restores the refrigerator's finished look and protects internal components from dust and damage. It's a direct-replacement exterior trim piece that keeps the cabinet edges sealed and visually complete. What it does:

• Covers and protects the refrigerator's side cavity and insulation from dust and contact
• Restores the appliance's exterior appearance after dents, scratches, or missing panels
• Helps keep internal components out of reach and reduces exposure to moisture and debris
• Matches the cabinet edge profile for a clean, factory-finish look

• Disconnect power to the appliance before starting any repair
• Remove any adjacent trim or shelving to access mounting screws
• Use appropriate hand tools; panel edges may be sharp—wear gloves to protect your hands
• Retain original fasteners; verify orientation and alignment before tightening screws

This screw is a factory replacement fastener used to secure appliance panels and components. It restores lost or loose hardware so parts sit correctly and operate without rattling or movement. What it does

• Secures panels, brackets, and small components to the appliance frame
• Restores proper alignment and helps eliminate rattling or vibration
• Replaces missing or stripped fasteners that prevent parts from staying fixed
• Matches OEM fit for reliable fastening where the original screw was used

• One replacement screw

• Use the correct-size screwdriver or driver bit to avoid stripping the head
• Power off and unplug the appliance before accessing internal components
• Tighten snugly but avoid overtightening to prevent thread damage
• Keep removed hardware organized so you can install replacements in the original locations

Front bracket and leveling screw assembly.

Rear bracket and leveling screw assembly.

Gas dryer application