Parts for Ge PTD70EBPT0RS: Cabinet & Top Panel Parts

This is a self-tapping sheet metal screw (8-18) used to secure internal components within the dryer. It threads into metal panels or brackets to hold parts firmly in place during operation. Replace if the screw is stripped, missing, or corroded, which can cause loose panels, rattling noises, or components shifting out of position.

Secures dryer panels and internal components to the cabinet frame. Replace if screw is stripped, missing, or loose to prevent vibration and rattling.

Size: 8-32 t. Includes 12 screws.

Bottom cover panel for dryers. Installs on the lower exterior of the cabinet. Replace if your existing panel is cracked, broken, or missing.

Adjustable leveling leg threads into the dryer base for stable footing. Replace missing, worn, or broken legs to level your unit on uneven floors.

Exterior top panel that covers and protects your dryer's internal components. Replace if cracked, dented, or damaged to restore a clean appearance.

Genuine mounting screw that secures dryer panels, brackets, and trim pieces to the frame. Replace when stripped, missing, or worn to restore proper fit.

Rear panel for your dryer. This panel forms the back of the dryer cabinet. Replace if cracked, damaged, rusted, or missing to restore appearance.

This fuse terminal cover shields and insulates the fuse connection inside your appliance, helping prevent accidental contact and shorting. Replace a cracked or missing cover to maintain safe electrical protection and dependable circuit performance.

• Covers and insulates the fuse terminals to protect the connection
• Helps prevent accidental contact, arcing, and debris intrusion at the fuse
• Common signs you need this part: missing cover, cracks, heat discoloration, or a cover that won't stay secured
• Promotes a secure, consistent fuse connection once installed

• Disconnect power at the breaker or unplug the appliance before servicing
• Access the fuse area per your service information; note wiring and cover orientation
• Remove the damaged cover; inspect terminals and wiring for heat damage or looseness
• Seat the new cover fully and verify it is secure and clear of wiring

Replacement strain relief bracket that secures the power cord at entry point. Needed when bracket is cracked, broken, or missing to restore safe cord routing.

The Water Valve is an OEM part for GE electric dryers. Located near the bottom of the machine, it controls water flow into the condenser system during moisture-sensing cycles.

The moisture sensing function uses this valve to introduce precise amounts of water vapor into the exhaust air stream periodically. This allows the condenser to capture moisture readings accurately and determine optimal cycle time based on humidity levels. 

Causes of failure include mineral buildup restricting flow, worn seals enabling leaks, or misaligned internal components hindering valve movement.

Symptoms of a faulty water valve are: 

• Loss of moisture sensing ability
• Incomplete or improper readings affecting cycle times  
• Water leaks from the valve area
• Failure to inject water vapor as needed

This part is also compatible with some Kenmore models using GE components.

If your dryer won't start, stops mid-cycle, or shows electrical issues, the main wiring harness may be damaged. This part restores power connections.

Includes 12 screws. Size: 8-18 ab.