Parts for Ge DCCH480EK0WW: 02 - Cabinet & Top Panel Parts

This genuine dryer heater assembly heats the air inside the dryer so clothes dry efficiently. It replaces a failed heating element to restore normal drying performance and reduce extended drying cycles. What it does:

• Generates the heat required for the dryer to remove moisture from laundry.
• Restores normal drying times when a worn or broken element causes little or no heat.
• Works with the dryer's thermal controls to maintain safe operating temperatures.
• Can stop dryer trips or error conditions caused by an open or shorted element.

• One dryer heater assembly (heating element)

• Disconnect electrical power to the dryer before beginning any work.
• Handle the element carefully — avoid bending or contacting the coil with sharp tools.
• Inspect and, if necessary, test the thermal fuse, thermostats, and wiring; replace any failed safety components.

This U-shape drain hose hanger secures the dishwasher drain hose to the cabinet or sink rim so the hose stays in the correct position and helps prevent kinks or improper drainage. A simple replacement that restores proper hose routing. What it does

• Holds the drain hose in a U-shaped loop to maintain proper high-loop or air gap positioning
• Keeps the hose away from sharp edges and hot components to reduce wear
• Helps prevent hose kinking that can cause slow draining or backups
• Useful when existing hanger is cracked, broken, or missing

• One U-shape drain hose hanger

• Turn off power to the appliance before accessing the drain hose area
• Typically installs by clipping or snapping around the hose and attaching to cabinet/sink edge—no special tools required
• Inspect the hose for damage and secure hose routing when replacing the hanger

This SCR cover-back is a replacement cover that protects the appliance's SCR module and wiring, helping prevent contact damage and debris buildup for reliable operation. It restores the original protective shielding. What it does

• Protects the SCR module, control board area, and wiring from physical damage and dirt
• Helps reduce risk of electrical shorting from loose debris or accidental contact
• Maintains factory routing and placement of components behind the control area
• Restores the appliance's original protective enclosure after service

• One SCR cover-back replacement panel

• Designed to fasten using the original screws or mounting hardware; all retained hardware is present
• Disconnect power before servicing to avoid shock or damage to electronic components
• Handle with care to avoid bending mounting tabs; align tabs before tightening screws
• If control boards or modules were removed for access, recheck connections before reapplying power