Parts for Ge DMCD330GJ2WC: Cabinet & Top Panel Parts

A 1/4" anchor nut that provides a threaded mounting point where a conventional nut can't be reached, letting screws thread securely into appliance sheet metal for a stable connection and reduced vibration noise. What it does:

• Creates a captive, threaded anchor in thin metal or panels where a standard nut can't be used
• Allows a mating screw or bolt to secure panels, brackets, or components
• Helps prevent loosening from vibration when used with the correct screw
• Commonly used in mounting and assembly tasks inside appliances

• One 1/4" anchor nut as shown

• Disconnect power and turn off water before servicing the appliance
• Access and replace the anchor nut from the panel or component area; use the matching screw/bolt size and proper hand tools
• Tighten to a snug fit—avoid over-torquing which can strip threads or deform thin panels

10-16 x 1/2 mounting screw secures panels, brackets, and internal components in your dryer. Replace when stripped, missing, or corroded for stable assembly.

Adjustable leveling leg threads into the dryer base for stable footing. Replace missing, worn, or broken legs to level your unit on uneven floors.

This silicon controlled rectifier (SCR) controls power flow to heating and motor circuits, restoring proper electronic regulation in appliances that use SCR-based control boards. Replaces a failed SCR to help return normal heat and motor control. What it does:

• Acts as a switch to regulate current to heating elements or motors when the control board signals it.
• Common symptom: unit fails to heat or run when the control board is commanding operation.
• Common symptom: intermittent or no power to specific circuits controlled by the SCR.
• Helps prevent erratic operation when the SCR is functioning properly.

• Disconnect power to the appliance before servicing to avoid shock or injury.
• Handle the SCR carefully; avoid bending the stud or damaging terminals.
• Mount and torque stud to specified appliance hardware; ensure good electrical contact and any required heat sink connection.

White side panel for dryers. Replace cracked, damaged, or discolored exterior panels. Restores appearance and protects internal components.

Mounting bracket for dryer front leveling leg. Secures adjustable leg to the cabinet base. Replace if bracket is cracked, bent, or broken to restore stability.

Secures and stabilizes the adjustable leveling leg on your dryer. Replace if the bracket is cracked, broken, or missing to keep your dryer level on uneven floors.

Front leveling leg and mounting bracket for dryers. Installs at the front base to support and level your dryer. Replace if broken, bent, or missing.

Adjustable leveling leg and bracket assembly for dryers. Installs at the base to stabilize and level your unit. Replace missing, broken, or worn feet.