Parts for Ge ZDP30L4D2SS: 03 - Case & Door Parts

This 30" landing ledge is the front trim piece that restores the finished edge and support at the oven's front opening, improving appearance and helping keep crumbs and spills from falling behind the unit. It replaces a cracked, bent, or missing ledge to return a clean, secure front surface. What it does

• Covers the seam at the front of the oven opening for a finished appearance
• Provides a stable front edge that helps prevent debris from falling into the cavity
• Replaces damaged or warped trim that can snag cookware or cause gaps
• Helps maintain proper alignment of adjacent trim and control surfaces

• One 30" landing ledge

• Disconnect power to the appliance before servicing
• Typically secures with a few screws or clips; keep removed fasteners for reinstallation
• Align the ledge into the front slots and fasten securely without over-tightening

This 27" oven broiler pan provides a durable tray for broiling and catching drips, helping keep the oven interior cleaner and supporting even heat under foods. Fits ovens requiring a full-width broiler pan. What it does:

• Catches grease and drippings while broiling to reduce flare-ups and simplify cleanup
• Supports food close to the broiler element for even browning and searing
• Restores proper fit and function when the original broiler pan is damaged, warped, or missing
• Works with standard 27" oven broiler systems designed for full-width pans

• One 27" oven broiler pan (single pan only)

• Slide into the broiler/grate position; no special tools required for most installations
• Ensure the oven is cool and disconnected from power before handling or cleaning
• Inspect for proper fit and stable seating before use; do not use if warped or cracked
• Clean according to oven manufacturer guidelines; avoid abrasive cleaners that could damage finish

This right body panel replaces the exterior side cabinet on compatible GE ranges and ovens, restoring a clean appearance and protecting internal components from damage. It's a direct-fit exterior side panel used to repair dents, rust, or missing side panels. What it does

• Covers and protects internal wiring, insulation, and components from physical damage
• Restores the appliance's exterior appearance and finish after dents, rust, or impact
• Helps maintain correct cabinet alignment and prevents gaps that can collect debris
• Eliminates sharp or damaged edges that can be a safety hazard

• Disconnect power (and gas, if applicable) before beginning any repair.
• Remove range/oven from enclosure as needed for safe access; support the unit to avoid tipping.
• Remove fasteners securing the old side panel, then align and secure the replacement panel with original hardware.
• Wear gloves to avoid cuts from sheet metal edges.