Parts for Ge PTE25SBTARSS: 07 - Case Parts

Replacement 8-18 x 9/16 machine screw for securing panels, brackets, and internal components. Needed when fasteners are stripped, missing, or worn.

Secures mobility components and wheel brackets on side-by-side refrigerators. Replace if screw is missing, stripped, or worn to restore stable mounting.

Top door hinge and pin assembly for refrigerators. Replaces broken, cracked, or worn hinges that cause door misalignment or sagging. Structural part.

Center hinge assembly for refrigerator doors. Installs between upper and lower doors to provide pivot support. Replace if hinge is cracked, bent, or worn.

This black plastic corner cap fits on the exterior corner of the refrigerator door, providing a finished appearance where trim pieces meet. It snaps into place to cover the joint at the door's edge. Replace this cap if it is cracked, broken, or missing, which can leave a gap and detract from the appliance's appearance.

Base grille kickplate that covers the compressor area at the bottom front of your refrigerator. Replace if cracked, broken, or missing.

Black plastic grille end cap for refrigerator base grilles. Replaces broken, cracked, or missing caps that secure grille panels at the edges.

Replace your refrigerator's door hinge cover if it's cracked, broken, or missing. This plastic cover installs over the hinge mechanism for a clean finish.

Replace missing or stripped #8-18 x 5/8-inch Torx T20 screws in your side-by-side refrigerator. Secures panels, brackets, drawer rails, and trim.

Replacement mounting screw for refrigerator panels, brackets, and hardware. Restores secure fit when original is missing, stripped, or corroded.