Parts for Bosch HBN5460UC/02: Cavity Parts

Interior light bulb illuminates your wall oven cavity so you can monitor cooking without opening the door. Replace when bulb burns out or flickers.

Uneven baking or slow heating in convection mode? A failed convection fan motor stops hot air circulation. Moderate DIY repair restores even cooking.

Catalyzer component for electric ovens and ranges. Installs inside the oven cavity. Order a replacement if your catalyzer is cracked, damaged, or missing.

Seals unused ports in your wall oven to prevent moisture and debris entry. Replace if missing, damaged, or leaking. Verify fit with your model number.

Restores a tight seal between your wall oven door and cabinet. Replace if worn, torn, or causing heat loss. Confirm fit by model number before ordering.

Fix an oven that won't reach set temperature or shows inaccurate readings. This temperature sensor monitors heat levels for proper cooking performance.

Oven won't heat when you press bake? This convection bake/broil heating element restores proper heating. Operates on 240V with under 1 amp draw.

Mounting hardware kit for wall ovens. Includes fasteners to secure panels and components. Replace missing, stripped, or damaged hardware for proper alignment.

Mounting hardware kit for wall ovens. Includes fasteners to secure panels and components. Replace missing, stripped, or damaged hardware for proper alignment.

This service access cover protects internal components and wiring while keeping the appliance's exterior neat. It restores a clean appearance and helps prevent accidental contact with internal parts during normal use. What it does:

• Protects internal components, connectors and wiring from dust and debris
• Helps reduce risk of accidental contact with electrical parts
• Restores the appliance's finished look after repairs or maintenance
• Useful when replacing or servicing nearby components that require the cover removed

• Disconnect power (unplug or switch off circuit breaker) before starting any work
• Remove and reinstall using the factory mounting clips or screws; avoid forcing the cover to prevent breakage
• Handle plastic tabs gently—inspect tabs and mounting points for damage before final install

Replace a cracked, discolored, or missing light reflector in your wall oven. Installs behind the oven light bulb to direct illumination into the cavity.

This is a mounting bracket that supports the interior shelf or turntable tray inside the microwave. It attaches to the interior wall of the unit and holds the shelf securely in place during operation. Replace this support if the shelf sits unevenly, wobbles during use, or if the original bracket is cracked or broken.

Oven not heating or baking unevenly? This bake element heats the oven cavity from the bottom. Moderately difficult repair requiring rear access.

Fix intermittent power or component failure with this range socket electrical connector. Restores secure wiring connections in electric and gas ranges.

Mounting screw for wall oven installation and panel assembly. Replaces lost, stripped, or damaged screws during service or reinstallation work.