Parts for Ge PT7550SF2SS: Center Spacer Parts

The Cooling Fan Lower is an OEM part for GE wall ovens. This lower fan helps circulate air through the lower cavity compartment to maintain safe internal temperatures.

Symptoms of a bad fan can include:  

• Excessive residual heat buildup in the lower cavity 
• Warm touch temperatures along lower oven exterior
• Fan motor making abnormal noises during operation

Causes usually involve degradation or failure of the electric fan motor from years of sustained use. Physical damage is also possible from accidental impacts. 

This genuine GE part is compatible with Hotpoint, RCA and select Kenmore models as well.

This is a replacement M4 hex nut used to secure small appliance panels, brackets, and assemblies. It provides a simple, reliable fastening point to restore proper fit and reduce rattles or loose parts. What it does:

• Secures panels, brackets, fasteners and small components in appliances
• Replaces missing or damaged nuts that allow parts to shift or rattle
• Restores proper thread engagement for M4-0.7 machine screws
• Helps maintain alignment of mounted assemblies when tightened correctly

• Turn off and unplug the appliance and remove power source before starting work
• Hand-start the nut to avoid cross-threading, then tighten snugly with the correct wrench; do not overtighten
• Replace any fasteners with damaged threads or stripped heads for a secure repair

The Cooling Fan Sensor is an OEM replacement part for GE ovens and ranges. It is a critical component that monitors and regulates the operation of the cooling fan, ensuring proper ventilation and temperature control within the appliance.

Symptoms of a bad cooling fan sensor:

• Overheating issues, with the oven or range becoming excessively hot
• Failure of the cooling fan to turn on or operate correctly
• Error codes or warning lights related to temperature or ventilation problems
• Potential safety hazards due to inadequate cooling and heat buildup

Causes of a faulty cooling fan sensor can include exposure to high temperatures over time, electrical malfunctions, or physical damage to the sensor or its wiring.

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore ovens and ranges.

This is a replacement #8-18 screw, 0.750 inches long with a nickel finish, used to secure panels and components on compatible appliances. It restores proper fastening and helps eliminate loose or rattling parts. What it does:

• Fastens appliance panels, brackets or small components where a #8-18 x 3/4" screw is required
• Replaces missing or damaged screws that cause loose panels, rattles, or misalignment
• Provides a corrosion-resistant nickel finish for longer-lasting attachment
• Matches OEM thread and length for a secure fit

• One (1) screw as shown

• Use the correct screwdriver or bit to avoid stripping the head
• Power off and unplug the appliance before accessing internal panels
• Replace only with the same size and thread to ensure proper fit; do not overtighten

Black. 8-18 AB HXW 3/8