Columbia Engine Parts

This flat washer is used to attach the idler pulley in a number of small and medium sized gasoline powered engines. These engines include snow blowers, log splitters, riding mowers, lawn tractors, and chippers. Because the idler pulley is subject to a great deal of resistance when the pulley is engaged, eventually the pulley will wear out. Should there be a squealing sound when engaging the drive, the problem is likely the idler pulley. In these cases, the pulley must be replaced. It is a good idea to replace the surrounding hardware when replacing the idler pulley; tNhis includes the flat washer, which is subject to corrosion during heavy use. To replace the idler pulley, first detach the spark plug cap. If on a mower or tractor, drop the mower deck. Remove the original pulley and install in order: replacement pulley, hex bolt, flat washer, flange nut. Apart from dropping the mower deck, the only tools required to complete this installation may be a 9/16 ratchet and combination wrench. This washer is a genuine OEM replacement part, designed to perfectly replicate the original piece. This washer is compatible with Troy-Bilt, Yard Man, Yard Machines, MTD, and Craftsman devices.

Deck lift cable for lawn tractors and riding mowers. Connects lift lever to mowing deck. Replace if cable is frayed, connectors are worn, or damaged.

Hex lock nut secures bolted joints on outdoor lawn equipment. Replace if threads are stripped, nut is missing, or won't hold proper tension.

This is a genuine replacement ignition key that is manufactured by MTD for use in select models of outdoor power equipment. The ignition key is a plastic piece that is inserted into the ignition cylinder to start the machine. Turning the plastic key will signal to the engine to fire. This is a durable plastic piece, but it can become damaged or lost over time, which will render the machine unable to start. Replacing it will be necessary in order to operate the unit. This genuine OEM ignition key is manufactured to exact standards. It can be used in snowblowers and snow throwers from MTD, Yard Machines, Troy-Bilt, Cub Cadet, Yard-Man, and Husky. The durable plastic key is sold as an individual unit and does not require any tools for installation. This is a simple replacement that should only take a couple of minutes. In the event that the old key is damaged or stuck in the ignition, it may take more effort. It is important to disconnect the power supply for safety before performing any repairs, as well as to wear gloves for hand protection.

Fuel filter for small engines on snowblowers, tillers, and lawn equipment. Replace annually or if engine runs rough to ensure clean fuel flow. Verify fit with your model number.

External gasket kit seals carburetor and engine surfaces on lawn equipment. Replace when you notice fuel leaks or loss of compression. Verify fit with your model.

Ignition coil for small engines on lawn and garden equipment. Replace if cracked, damaged, or worn. Includes spark plug boot and wire assembly.

Snowblower won't start or pulls hard? This recoil starter assembly restores reliable pull-start function. Common repair for worn or broken recoil.

Plastic primer bulb that draws fuel into the carburetor when pressed. Replace if cracked, broken, or no longer creating proper seal for priming.

This small tension spring connects to the governor arm on the engine, helping regulate engine speed under varying load conditions. It ensures the throttle responds properly to maintain consistent RPMs. Replace this spring if your engine surges, runs erratically, or fails to maintain a steady speed during operation.

Fuel cap for gas-powered engines and outdoor power equipment. Seals fuel tank to prevent debris, dirt, and air contamination. Replace if cracked or loose.

Carburetor assembly for snow throwers. Mounts to the engine block to mix air and fuel. Replace if cracked, leaking, or worn to restore proper operation.

Bell washer for lawn mowers and tractors. Installs to secure components and prevent loosening. Replace if cracked, worn, or missing for proper assembly.

Complete fuel tank assembly for snow throwers and tillers. Includes tank and mounting hardware. Replace if cracked, leaking, or damaged during storage.