Parts for Frigidaire 5138007E: Compressor Parts

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This terminal cover gasket seals and cushions the appliance's electrical terminal cover to help block dust and moisture while providing an insulating barrier around the power connection. It's a direct-fit replacement for worn or damaged seals. What it does:

• Seals the area around the terminal cover to help keep out dust, moisture, and debris
• Cushions and positions the terminal cover to reduce vibration and contact wear
• Provides electrical insulation around the terminal area for safer operation
• Commonly replaced when the cover is cracked, deformed, or no longer seals properly

• Disconnect power (unplug or shut off breaker) before servicing electrical terminals
• Remove the terminal cover per your model's service instructions, replace gasket, and re-seat cover fully
• Inspect terminal cover and wiring; replace any cracked covers or damaged wires before reassembly

This replacement terminal cover protects the appliance's power terminal block and wiring from accidental contact and debris, restoring a safe enclosure for the live electrical connections. What it does:

• Protects the terminal block and wiring from accidental contact, dust and debris
• Helps prevent arcing, sparks or shorting caused by exposed terminals
• Secures the routing area around power connections for safer operation
• Useful when original cover is cracked, melted, missing or shows burn marks

• Always disconnect power at the breaker or unplug the appliance before servicing
• Remove access panel or back panel to reach the terminal block; reinstall cover so it fully encloses the terminals
• Use appropriate fasteners if required; ensure all wire terminals are tight and positioned before replacing the cover
• If wiring or the terminal block shows damage or corrosion, replace or repair those components before restoring power

This overload protector is a direct-replacement compressor protector that helps prevent compressor damage by cutting power when the motor overheats or draws excessive current. It restores normal operation once the compressor cools. What it does:

• Protects the refrigerator compressor from overheating and overcurrent conditions
• Interrupts power when the compressor draws excessive current or fails to start
• Common symptom link: fridge not cooling while compressor hums, clicks, or won't run
• Works with the compressor's start components to help prevent motor burnout

• Disconnect electrical power to the appliance before accessing the compressor
• Mounts to and plugs onto the compressor terminals; ensure firm, clean connections
• No refrigerant handling is required for this part; do not open sealed refrigeration lines

Fix an AC compressor that won't start or struggles to turn on with this start assist kit. Helps older units start reliably. DIY-friendly installation.