Parts for Bosch B26FT80SNS/04: Compressor Parts

This damper assembly controls oven vent airflow so the oven reaches and holds the correct temperature and venting. Replaces a worn or stuck vent flap to restore normal oven cycling and heat distribution. What it does:

• Opens and closes the oven vent to regulate airflow during bake, broil, and self-clean cycles
• Helps the oven maintain temperature by allowing excess heat to escape when needed
• Commonly linked to symptoms like uneven baking, persistent high internal temperature, or a stuck vent that won't open
• Functions as a direct replacement part when the existing vent flap or actuator is damaged or fails

• Disconnect power to the appliance before attempting service
• Access may require removing the oven rear panel or control housing; follow the OEM service manual
• Handle the damper gently to avoid bending the flap or damaging the actuator linkage

Power supply cable for bottom-mount refrigerators. Connects electrical components inside the appliance. Replace if cable is frayed, damaged, or worn.

This fastening ring secures and retains a specific component assembly in place on select Bosch appliances, helping maintain proper alignment and operation. It's a simple replacement part that restores secure mounting where the original ring is worn or damaged. What it does:

• Holds a component or housing securely to prevent movement and rattling
• Restores proper alignment of the retained part to reduce noise and vibration
• Helps maintain a sealed or fixed connection where applicable
• Commonly replaced when the original ring is bent, cracked, or corroded

• Disconnect power (and water if applicable) before beginning any repair
• Use basic hand tools; avoid excessive force to prevent damage to adjacent parts
• Inspect mating surfaces and related fasteners; replace any damaged components

Fix uneven cooling or temperature swings in your refrigerator by replacing a stuck or broken damper control. This part regulates airflow between compartments.

This temperature limiter is a factory-style safety device that opens the circuit when internal temperatures exceed a safe threshold, helping protect heating components and wiring from overheating. What it does:

• Monitors internal temperature and interrupts power when the preset limit is exceeded
• Prevents overheating-related damage to heating elements and nearby components
• Can cause the appliance to stop heating or fail to run if the limiter has opened
• Acts as a safety backup when primary thermostats or controls fail

• Always disconnect power (unplug or switch off circuit breaker) before servicing
• Replace only with the exact OEM part number to maintain safety ratings
• Avoid touching terminals with power connected; confirm wiring matches original
• If the limiter has opened, inspect surrounding components for root causes before returning appliance to service