Parts for Kenmore 253.70107001 (25370107001, 253 70107001): Compressor Parts

Fix an air conditioner that won't cool or runs constantly with a new compressor. This repair requires refrigerant recovery and proper certification.

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This terminal cover gasket seals and cushions the appliance's electrical terminal cover to help block dust and moisture while providing an insulating barrier around the power connection. It's a direct-fit replacement for worn or damaged seals. What it does:

• Seals the area around the terminal cover to help keep out dust, moisture, and debris
• Cushions and positions the terminal cover to reduce vibration and contact wear
• Provides electrical insulation around the terminal area for safer operation
• Commonly replaced when the cover is cracked, deformed, or no longer seals properly

• Disconnect power (unplug or shut off breaker) before servicing electrical terminals
• Remove the terminal cover per your model's service instructions, replace gasket, and re-seat cover fully
• Inspect terminal cover and wiring; replace any cracked covers or damaged wires before reassembly

Replace a faulty overload protector if your air conditioner compressor won't start or cycles off frequently. Direct-fit part for reliable operation.

This base tray is the OEM replacement panel that supports internal components and helps contain spills for proper drainage and appliance stability. Replacing a damaged tray restores a secure interior fit and reduces leaks or debris buildup. What it does:

• Provides a stable support surface for lower interior components and accessories
• Channels or contains minor spills to help prevent water from reaching electronics or cabinet floor
• Restores proper alignment and fit when original tray is cracked, warped, or broken
• Helps eliminate rattles or movement caused by a damaged or loose base

• Base tray as shown

• Disconnect power to the appliance before starting any repair
• Remove surrounding panels or components per OEM instructions to access the tray
• Inspect mounting tabs and seals; align tray carefully and avoid forcing it into place
• Replace with manufacturer-specified hardware and test for leaks after reassembly

This part has been discontinued by the manufacturer and is no longer available.