Parts for Kenmore 253.70124001 (25370124001, 253 70124001): Compressor Parts

Fix an air conditioner that won't cool or runs constantly with a new compressor. This repair requires refrigerant recovery and proper certification.

Replace worn compressor mounting grommets to stop excessive vibration and noise. Fits most air conditioner and heat pump models. Simple DIY fix.

This terminal cover gasket seals and cushions the appliance's electrical terminal cover to help block dust and moisture while providing an insulating barrier around the power connection. It's a direct-fit replacement for worn or damaged seals. What it does:

• Seals the area around the terminal cover to help keep out dust, moisture, and debris
• Cushions and positions the terminal cover to reduce vibration and contact wear
• Provides electrical insulation around the terminal area for safer operation
• Commonly replaced when the cover is cracked, deformed, or no longer seals properly

• Disconnect power (unplug or shut off breaker) before servicing electrical terminals
• Remove the terminal cover per your model's service instructions, replace gasket, and re-seat cover fully
• Inspect terminal cover and wiring; replace any cracked covers or damaged wires before reassembly

Fix heating issues in your air conditioner or heat pump with this heater thermostat. Restores proper temperature control and system cycling.

This part has been discontinued by the manufacturer and is no longer available.

This is a valve mounting screw that secures a valve assembly to the appliance, helping keep the valve stable and properly aligned during normal operation. It's a direct-fit replacement for the listed OEM part number. What it does:

• Fastens the valve assembly to the appliance frame or valve body
• Prevents valve movement that can cause vibration noise or misalignment
• Helps maintain proper sealing and connection of the valve assembly
• Used wherever the OEM valve screw is specified

• Disconnect power (and gas if applicable) before starting any repair
• Handle small parts carefully and keep hardware organized to avoid loss
• Thread into place by hand, then tighten with appropriate driver; avoid overtightening
• Inspect valve connections after reassembly and test appliance function per manufacturer instructions