Parts for Maytag GT1887PEKW: Compressor Parts

This genuine replacement screw secures appliance panels and components to restore proper fit and reduce rattling or movement. Use it when a missing or damaged screw prevents panels, brackets, or controls from staying tight. What it does:

• Fastens panels, brackets, or assemblies to the appliance frame
• Helps stop vibration noise and loose parts caused by a missing or stripped screw
• Restores factory fit where an original screw is lost or damaged
• Compatible with common interior and exterior mounting locations as specified by the manufacturer

• Use the correct matching screw hole and thread engagement; do not force a misaligned screw
• Hand-start the screw to avoid cross-threading, then tighten with the proper driver
• Replace any stripped or damaged mating hardware for a secure fit
• Disconnect power before working near electrical components and follow all safety instructions in the appliance manual

This running capacitor restores proper motor operation by providing the phase shift needed for fan and compressor motors. It helps motors run smoothly and reduces overheating or hard-start symptoms when the original capacitor fails. What it does:

• Provides the steady electrical phase shift required for motor operation in refrigeration and HVAC systems
• Helps restore normal motor starting and running performance
• Can reduce motor overheating, humming, or intermittent operation caused by a bad capacitor
• Used when the motor runs poorly, won't reach full speed, or cycles unusually

• 1 running capacitor

• Disconnect power at the breaker and verify the appliance is de-energized before servicing
• Discharge the capacitor with an insulated tool and wear insulated gloves and eye protection
• Replace with the same type and mounting orientation; secure all wire connections firmly

Size: 8-32 x .312 inch.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal