Parts for Frigidaire DG27S6DVFA: 04 - Console And Control Parts

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

This switch allows you to select different heat settings on your dryer for various fabric types. It controls the heating element operation to provide low, medium, and high temperature options. If your dryer only heats on one setting or doesn't heat at all when you change temperature selections, this switch likely needs replacement.

Replace a broken or worn control panel pushbutton on your dryer. This button installs on the control panel to restore manual operation and appearance.

This is a replacement mounting screw used to secure a solenoid valve or solenoid assembly in appliances. It provides a durable fastening point so the solenoid stays properly positioned and functions reliably. What it does:

• Secures solenoid valves or solenoid assemblies to the appliance frame or bracket
• Helps maintain correct alignment for valve operation and connections
• Prevents loosening from vibration or normal use
• Suitable where the OEM fastener is required for a proper fit

• Use the matching screw size and thread pattern listed in the appliance parts diagram
• Tighten to snug only; overtightening can strip threads or damage the solenoid housing
• Disconnect power and shut off water before servicing the appliance
• If other fasteners or damaged components are present, inspect and replace as needed

This timer shield is a molded cover that protects the appliance's timer/control mechanism from dust, debris and accidental contact, helping the timer operate reliably and extending component life. What it does:

• Covers the timer assembly to shield electrical contacts and the timer shaft from contaminants
• Reduces risk of shorting from debris or accidental contact with the timer
• Helps prevent intermittent timer operation caused by dirt or physical interference
• Appropriate for repairs where the original timer cover is cracked, missing, or damaged

• Disconnect power to the appliance before beginning any service
• Remove any control knobs or bezel needed to access the timer, then snap or screw the shield into place per the original orientation
• Inspect surrounding components (timer mounting, wiring) while the control is exposed; replace damaged parts as needed

Size: 3/4 inch od x 1/4 inch id.