Parts for Ge GCG1520Z1BB: 03 - Container Parts

Due to the manufacturer change the original black handle has been replace with dark brown.

This Ring "E" trim ring is a small OEM appliance replacement that secures and protects adjacent components, helping maintain proper alignment and reduce wear. It restores correct fit where the original ring is cracked, warped, or missing. What it does:

• Holds nearby trim or sealing parts in place to prevent rubbing and misalignment
• Helps maintain an even seal and component spacing that supports normal operation
• Commonly replaced when the original ring is broken, deformed, or lost during service
• Does not change appliance function by itself but prevents related cosmetic and fit issues

• One Ring "E" trim ring

• Install only on the specified location shown in the appliance parts diagram; verify orientation before fastening
• Use basic hand tools; avoid over-tightening fasteners that could crack the ring
• Disconnect power (and shut off water if applicable) before servicing nearby components
• If other parts show damage, inspect adjacent seals, clips, or trim for concurrent wear

Container bumper for trash compactors. Installs on the compaction container to cushion impact and reduce noise. Replace if cracked, worn, or missing.

For complete bag carrier order WC36X10015.

Durable trash compactor bags designed to withstand compaction force without tearing or leaking. Replace worn, torn, or missing bags in your compactor unit.

This adhesive insulation is a thin, self-stick insulating strip that helps reduce heat transfer and dampen vibration where applied. It restores proper insulation and can improve efficiency and condensation control in affected areas. What it does:

• Provides a thermal barrier to help reduce heat transfer between components or panels
• Dampens vibration and minimizes noise from rubbing or contact points
• Helps reduce condensation by insulating cold surfaces from warmer air
• Keeps gaps sealed where insulation has deteriorated or fallen away

• Disconnect power before accessing appliance panels or internal areas
• Remove old insulation and thoroughly clean and dry the mounting surface for best adhesion
• Align the strip and press firmly to ensure full contact; trim if necessary to fit
• Use caution around sharp edges and wiring