Parts for Ge GCG1700L0II: 03 - Container Parts

This complete Door assembly II replaces a damaged or worn refrigerator door to restore fit, seal and appearance. It provides the full door panel and mounting points so the door closes properly and protects cooled compartments. What it does

• Replaces a cracked, dented or misshapen door panel that prevents proper sealing
• Restores door alignment and hinge mounting for smooth opening and closing
• Re-establishes the barrier that helps maintain internal temperature and energy efficiency
• Provides factory mounting surfaces for bins, trim and gasket to secure interior storage

• Disconnect power and remove food and shelves from the door area before starting
• This is a large component; two people and basic hand tools are usually required for safe handling and installation
• Support the door while removing hinge hardware to avoid dropping or bending
• After installation, check door alignment and gasket seating; allow time for the door to settle before final adjustments

Fix a compactor door that won't stay closed or latch properly with this door latch assembly. Common repair for loose or broken door mechanisms.

This latch plate assembly secures the dryer door and engages the door switch so the machine can run. It restores proper door closure and helps ensure the dryer starts and runs safely. What it does:

• Provides the metal strike for the door latch to catch and hold the door closed
• Engages the dryer door switch so the appliance recognizes a closed door
• Commonly used when the door won't stay closed, the dryer won't start, or the door strike is bent or worn
• Fits into the door frame and works with the latch mechanism to restore secure closure

• Disconnect power before installing to avoid shock or injury
• Removal typically requires opening the dryer door and replacing screws that hold the plate to the door frame
• Check the mating latch for wear and alignment; adjust as needed for smooth operation

Replaces the lower front grille panel on your trash compactor. Restores finished appearance and protects internal components when cracked, split, or damaged.

Drawer roller assembly for trash compactors. Guides the compactor drawer in and out smoothly. Replace if cracked, broken, or causing friction during use.

This retainer bag secures and positions the bag/assembly inside the appliance so the component stays in place during normal use, helping prevent sagging or misalignment. It's a direct-fit replacement designed to restore proper fit and function. What it does:

• Holds the bag or internal assembly securely in the correct position
• Prevents the bag from shifting, sagging, or catching during operation
• Helps maintain proper airflow and component alignment where applicable
• Resolves symptoms like a loose, sagging, or improperly seated bag/assembly

• One retainer bag

• Disconnect power to the appliance before starting any work
• Remove exterior panels or access covers as required to reach the retainer
• Inspect surrounding clips and mounting points; replace damaged fasteners as needed
• Follow the appliance manufacturer's instructions for reassembly and testing

Replacement rear guide for trash compactor door latch assembly. Aligns and supports the latch mechanism for secure closing. Needed when original is cracked or worn.

This shoulder screw secures and guides the foot assembly, providing a precise shoulder for alignment and smooth movement. Replacing a worn or missing screw restores a snug, reliable fit and consistent operation of the attached component.

• Positions and secures the foot component at its mounting point
• Provides a smooth shoulder/bearing surface for proper alignment and motion
• Helps resolve looseness, wobble, binding, or misalignment in the foot assembly
• Replace if the original screw is stripped, bent, corroded, or missing

• Disconnect power to the appliance before servicing
• Support the assembly to remove any load before removing hardware
• Retain any spacers or washers and reinstall in the original order
• Hand-start threads to avoid cross-threading; tighten snugly without overtightening