Parts for Viking Range VGRT36: Control Assembly Parts

Replace a gas cooktop control panel with unresponsive buttons or damaged surface. This stainless steel panel restores full cooktop functionality.

The range knob bezel is the decorative ring that surrounds control knobs on your range's front panel. Replace this part when it becomes cracked, discolored, or loose, affecting the appearance and proper seating of control knobs.

Replacement burner control knob for gas ranges and cooktops. Installs on the control panel to operate burner valves. Needed when original is cracked or missing.

This is a top burner knob that is used on oven ranges that were manufactured prior to 2003. A burner knob is what the user turns to adjust the temperature on the burner. This part is manufactured out of a black plastic material and has white lettering on it.A new top burner knob may be needed if the original is cracked, broken, or damaged in any way. If any of the letters wear off of the knob, the user may wish to replace it. If the back of the knob is stripped out and it just spins without activating the range, then it will need to be replaced.This top burner knob is a genuine Viking part and is an OEM part sourced directly from the manufacturer. It is sold individually. This particular top burner knob is compatible with oven ranges that are manufactured by the Viking brand.

This 1/2" x 1/4" rubber bumper cushions contact points to reduce noise and prevent damage on appliance doors, drawers, and panels. It restores proper cushioning for smoother, quieter operation and helps maintain a snug fit. What it does:

• Absorbs shock where panels or doors meet to reduce rattling and clapping noises
• Prevents metal-to-metal contact that can cause chipping, scratching, or wear
• Helps doors and drawers close more evenly by restoring original spacing
• Commonly used where small, press-fit bumpers have worn, flattened, or fallen off

• One 1/2" x 1/4" rubber bumper

• Press-fit replacement; remove old bumper and press new bumper into the same hole until flush
• No special tools required; use a flat pick or small screwdriver to remove old bumper if needed
• Avoid installing on hot surfaces or near heating elements; let appliance cool before service
• Replace matching bumpers in the same area if others show wear for even performance

This is the wire assembly that connects the spark module to the rear burner ignitor on a gas range. It carries the electrical pulse needed to create a spark that ignites the gas at the burner. Replace this wire if the rear burner clicks but does not light, produces no spark at all, or if the wire insulation is damaged or burned.

This wire connects the spark module to the grill or griddle burner ignitor on a gas range. It carries the electrical spark signal needed to ignite the burner. Replace this wire if your grill or griddle burner clicks but won't ignite, or if you notice intermittent ignition failure due to a damaged or corroded wire.