Parts for Thermador KBURT3675E01: Control Asy Parts

This Bosch filter removes contaminants and improves water taste. The filter should be changed every six months for best performance. Simple installation requires no special tools. Measures approximately 13.25" x 2.5" x 2.5".

This fan blade replaces a damaged or worn blower blade to restore proper airflow and reduce noise. It helps the appliance circulate air efficiently so cooling and ventilation perform as intended. What it does:

• Moves air across the evaporator/heatsink or within the appliance cabinet to support cooling and ventilation
• Restores full airflow when the original blade is cracked, warped, or missing
• Helps reduce rubbing, vibration, and unusual fan noise caused by damaged blades
• Prevents motor strain that can occur when an imbalanced or broken blade is used

• Disconnect power to the appliance before beginning any repair
• Handle the blade carefully to avoid bending the impeller fins
• Inspect the motor shaft, set screw, and mounting hardware; replace any damaged fasteners

The Fan Motor is an OEM replacement part for Bosch refrigerators. It circulates cold air inside the insulated liner maintaining precise temperatures. Unhindered airflow locks in freshness. 

Causes of a bad fan motor involve enduring years of constant rotation which stresses motor windings and bearing surfaces beyond rated lifetimes. Vibration and ambient heat accelerate breakdowns.

Symptoms of a bad fan motor include:  

• Loss of desired cooling capacity as air fails to circulate    
• Temperature fluctuations that compromise perishables  
• Audible grinding or rattling from within the fridge's interior
• Failed fan blades detaching pose potential fridge hazards

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

This air baffle assembly controls airflow between refrigerator compartments to help maintain even temperatures and proper circulation. Replaces a worn or broken damper to reduce uneven cooling and airflow issues. What it does:

• Directs cold air from the evaporator into the fresh food and freezer sections
• Helps maintain consistent temperatures by opening and closing airflow paths
• Commonly replaces units that are cracked, stuck, or no longer sealing properly
• Can reduce symptoms like uneven cooling, warm spots, or excessive frost buildup near the evaporator

• One air baffle assembly

• Disconnect power before servicing to avoid shock or injury
• Remove interior panels or shelving as needed for access; handle the baffle carefully to avoid damage
• Align tabs and mounting points; ensure the damper moves freely after installation
• Follow the refrigerator's service manual or manufacturer instructions for model-specific removal and torque details

The Thermistor is an OEM part for Bosch refrigerators. It monitors the temperature inside the refrigerator and communicating it to the control board. The thermistor plays a vital role in maintaining the optimal cooling performance and ensuring food is stored at a safe and proper temperature.

Causes of a bad thermistor can include failure due to age, exposure to excessive heat or cold, or damage from impact or moisture.

Symptoms of a bad thermistor include:

• Inconsistent or fluctuating interior refrigerator temperature
• The refrigerator failing to cool properly
• Error codes or fault messages showing on the control panel

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

A replacement door switch that senses when the appliance door is closed and allows the unit to operate. Restores normal safety interlock function so the appliance only runs with the door properly shut. What it does

• Detects door closure and completes the circuit to allow the appliance to start or run.
• Prevents operation when the door is open, helping keep users safe.
• Commonly linked to symptoms such as the appliance not starting, stopping mid-cycle, or controls not responding when the door is shut.
• Works as a direct electrical interface for the door latch or catch assembly.

• Disconnect power (unplug or shut off circuit breaker) before accessing the switch.
• Remove required access panels or the door inner panel; handle sharp edges and glass with care.
• Confirm wiring and connector orientation match the replacement; secure all fasteners and reassemble panels fully.