Parts for Lg RV13U7ES8W: Control Panel And Plate Assembly Parts

A replacement front panel assembly that restores the appliance's exterior console and control area for a factory-finish look. Replaces a cracked, faded, or damaged outer console so buttons and display mount securely. What it does:

• Replaces the outer front console and provides the mounting surface for control buttons and display
• Restores cosmetic finish and alignment when the original panel is cracked, warped, or broken
• Helps eliminate rattles or loose trim caused by damaged panel edges or broken clips
• Works with existing controls and electronics

• One front panel assembly (outer console) as pictured

• High-level replacement: remove top/control housing and detach retaining clips/screws; save hardware for reinstallation
• Handle panel carefully to avoid scratching the finish or damaging mounting tabs
• Disconnect power before starting and follow appliance-specific disassembly steps in the service manual

Front trim decor panel that restores the finished appearance of your dryer door assembly. Replaces cracked, scratched, faded, or missing decorative trim.

Fix a blank or unresponsive dryer display with this display power control board assembly. Restores touch controls and button functions when the interface fails.

Replaces a cracked, broken, stripped, or missing control knob on your dryer or washer. Restores secure grip and proper engagement with the control shaft.

This main printed circuit board (power control board assembly) controls core appliance functions and electrical power distribution for the control system. Replacing a faulty board restores responsive controls and reliable power management. What it does:

• Regulates power to the appliance control circuits and coordinates electronic functions.
• Processes user inputs and sends signals to motors, valves, heaters, and display modules.
• Common symptoms of a failing board: appliance won't power on, unresponsive controls, erratic behavior, or persistent control-related error codes.
• Use only the exact replacement board to avoid compatibility and safety issues.

• Disconnect power (unplug or switch off circuit breaker) before service.
• Take photos or label wiring connectors to ensure correct reassembly.
• Avoid touching circuit traces or components; handle board by edges and ground yourself to prevent static damage.

This main PCB power control board assembly regulates power and coordinates the appliance's electronic functions so your unit can start, run cycles, and respond to controls. Replace a faulty board to restore reliable operation and control communication. What it does:

• Manages power distribution to motors, valves, sensors and other electronic modules
• Processes commands from the user interface and runs control logic for cycles and timing
• Communicates status to display and other control boards
• Faulty boards can cause symptoms such as no power, no response to controls, intermittent operation, error codes, or unexpected stops

• One main PCB power control board assembly

• Disconnect power at the breaker or unplug the appliance before servicing
• Boards are static-sensitive; ground yourself and handle by the edges
• Inspect connectors and wiring for damage before and after installation

This replacement top plate assembly is the upper cooktop panel for your range. It provides a flat, secure surface for burner components and protects the chassis below from heat, spills, and everyday wear.

• Forms the cooktop surface and mounting points for burner components
• Shields internal wiring/valves from spills, heat, and debris
• Damage can cause burners or grates to sit unevenly or create sharp edges/gaps
• Restores appearance and proper support when the original is dented, warped, or rusted

• Disconnect power; shut off gas and allow the appliance to cool
• Remove grates, burner caps and heads; disconnect igniter wires as needed
• Remove mounting screws, lift off the old panel, and set the new assembly in place
• Wear cut-resistant gloves and verify proper burner operation after reassembly

Protective cover shields internal wiring and electrical terminals in your dryer. Replace if cracked, broken, or missing to prevent accidental contact.