Parts for Ge JP256BM1BB: 01 - Control Panel & Cooktop Parts

Replace your cooktop's burner box assembly if the metal chassis is cracked, warped, rusted, or damaged. This structural base supports burners and components.

Replace a cooktop burner element that won't heat, heats unevenly, or stays on continuously. Fits standard 6-inch coil burners on electric cooktops.

Mounting screw for range hood installation. Secures hood to cabinet or wall bracket. Replace if stripped, missing, or damaged during installation.

Fix a cooktop burner heating only on inner or outer ring, or not heating at all. This dual radiant element restores both heating zones. DIY repair.

White control knob for electric ranges and cooktops. Replaces broken, cracked, or missing knobs on burner controls. Direct-fit replacement part.

Burner won't regulate temperature or cycles incorrectly? This infinite switch controls variable heat output for your cooktop element. Moderate DIY repair.

Fix a burner stuck on high or not heating with this infinite control switch. Common cause when burners won't adjust temperature. DIY repair in 20 minutes.

This seal cushions and seals the refrigerator/freezer lamp assembly to keep condensation and dust out while protecting the lamp. It restores the light housing fit for reliable illumination and a neater interior. What it does:

• Forms a watertight/air-resistant gasket around the lamp housing to reduce moisture and debris intrusion
• Helps keep the lamp assembly securely seated so the bulb and lens stay in place
• Can stop light from leaking into adjacent compartments or behind trim
• Commonly replaced when the seal is cracked, brittle, missing, or allowing moisture buildup around the lamp

• One lamp seal

• Disconnect power (unplug or shut off circuit) before servicing any lighting component
• Remove lamp lens/assembly per your model's instructions before replacing the seal
• Inspect surrounding housing for cracks or damage; replace any broken parts to ensure a proper seal
• Use only the specified OEM seal to maintain fit and avoid trimming or forcing parts

Seals the gap around cooktop door glass and shaft to contain heat and moisture. Replace when worn or damaged to restore proper sealing and performance.

Threaded mounting stud secures your cooktop to the countertop or cabinet. Replace if stripped, broken, or missing to properly anchor the unit.