Parts for Craftsman 917881061: Control Panel / Discharge Chute Parts

This replacement part is an electronic circuit board for range hoods. A range hood is the metal piece on top of the stove that holds the fan. It functions as a ventilation system to filter and circulate the air, smoke, and heat coming from the stove while cooking. The electronic circuit board controls the main functions of the range hood.Before installing this part, make sure that the range hood is unplugged, or turn off the circuit breaker that goes to the range. The circuit board is located within the chimney above the motor. First, unthread the four screws holding down the circuit board. After the screws are removed, take off the cover. Line up the new circuit board with the old one, and replace the old wires into the correct terminals on the new circuit board. This might require a pair of needle-nose pliers. Once wires have been connected properly, remove the ribbon wire from the old board and place it into the new. Uninstall the old circuit board by removing the screws that secure it. Secure the new circuit board in place of the old by fastening the screws back into their original place.This genuine OEM replacement part is compatible with Bosch, Gaggenau, and Thermador range hoods.

This small rubber gasket seals and cushions an M4 fastener to help prevent leaks and reduce vibration at attachment points. It's a compact replacement part used where a watertight or vibration-damping seal is needed. What it does:

• Creates a seal around an M4 screw or bolt to help prevent water intrusion
• Cushions fasteners to reduce vibration, noise, and metal-on-metal wear
• Restores a tightened fastener's proper sealing surface when the original gasket is worn
• Helps maintain appliance integrity around panels, brackets, or connections

• Power off and unplug the appliance before starting any repair.
• Confirm the gasket's size matches the fastener and seating area before installation.
• Install flat against the mating surface; tighten fastener snugly but avoid over-torquing which can deform the gasket.
• Handle small parts carefully and retain any removed hardware for reassembly.