Parts for Frigidaire FGBM15WCVFA: Control Panel,Door Parts

Fix a microwave that won't start, has no display, or buttons don't respond with this control board. Compatible with combo units. Moderate difficulty repair.

This access panel cover replaces a cracked or missing exterior cover to protect internal components and restore a finished appearance. It keeps wiring and controls shielded while preventing drafts and debris from entering. What it does

• Protects internal parts and wiring from dust and physical damage
• Restores the appliance's finished exterior where a cover was broken or removed
• Stops rattling or airflow issues caused by a loose or missing panel
• Helps maintain safe, enclosed access to service areas

• One cover/access panel

• Disconnect power to the appliance before starting any repair
• Remove fasteners holding the old cover and lift out carefully to avoid damaging clips
• Align replacement cover, secure with original screws or clips, and confirm a snug fit
• If mounting hardware is damaged or missing, replace with OEM-specified fasteners

This door gasket creates a tight seal around the refrigerator door to help keep cold air in and warm air out, improving cooling consistency and reducing energy use. What it does:

• Seals the door edge to maintain proper internal temperature and reduce frost buildup
• Prevents warm, humid air from entering the cabinet
• Helps the compressor run less frequently by improving insulation
• Commonly replaced for visible cracks, tears, or weak/magnetic seal

• One door gasket

• Remove the old gasket and clean the mating surface before installing the new seal
• Warm the gasket slightly for easier fit and to help conform to the door frame
• Check that the magnetic edge seats fully around the door; adjust or re-seat as needed

Fix a microwave door that won't close or stay shut with this door latch. Secures the door in the closed position for safe operation and proper cycling.

Wire harness for microwave/hood combo units. Connects electrical components inside the appliance. Replace if damaged, frayed, or connections are loose.

This genuine-style control panel restores the washer's front console so you can access buttons and cycle displays cleanly. It replaces cracked, warped, or cosmetically damaged panels to return the appliance to normal user operation and appearance. What it does:

• Provides the front-facing surface and button/interface mounting for the appliance control area
• Restores safe, accessible operation when the original panel is cracked, loose, or broken
• Protects internal switches and electronics from debris and moisture at the console
• Improves appearance by replacing scratched or faded panels

• Disconnect power to the appliance before attempting service
• Handle edges and mounting tabs carefully to avoid damage during removal/installation
• Retain any screws, clips, or bezels removed; some models require trim removal to access the panel