Parts for Bosch HBL5650UC/01: Control Panel Parts

The Interface is an OEM part for Bosch ovens. It serves as the control center for your oven, allowing you to select and adjust various settings for cooking, baking, and other functions. The interface is responsible for providing a user-friendly interface for easy operation.

A bad interface can occur due to electrical surges, component failure, or physical damage. Signs of a faulty board include unresponsive buttons, erratic display, or inability to adjust settings.

Symptoms of a bad interface include:

• Unresponsive buttons or erratic display  
• Inability to adjust settings
• Error codes displayed 

Replace your malfunctioning interface with this genuine OEM Bosch part to restore your oven. This Bosch part can also be used on Thermador and Gaggenau appliances.
 

The Interface is an OEM part for Bosch ovens. It serves as the control center for your oven, allowing you to select and adjust various settings for cooking, baking, and other functions. The interface is responsible for providing a user-friendly interface for easy operation.

A bad interface can occur due to electrical surges, component failure, or physical damage. Signs of a faulty board include unresponsive buttons, erratic display, or inability to adjust settings.

Symptoms of a bad interface include:

• Unresponsive buttons or erratic display  
• Inability to adjust settings
• Error codes displayed 

Replace your malfunctioning interface with this genuine OEM Bosch part to restore your oven. This Bosch part can also be used on Thermador and Gaggenau appliances.
 

This replacement control knob restores user control for a range of oven or cooktop function selector. It provides a secure grip and clear pointer for accurate setting selection so you can operate the appliance confidently. What it does:

• Replaces a worn, cracked, or missing front-mounted control knob used to set temperature or burner/oven functions
• Provides a tactile grip and visible pointer for precise selection of settings
• Helps eliminate slipping or intermittent control caused by damaged knobs
• Compatible where this exact OEM knob PN is specified

• One replacement control knob

• Remove power to the appliance before servicing to avoid injury
• Pull old knob straight off the splined shaft; align new knob and push on until fully seated
• If knob does not fit, check OEM part number and shaft type before forcing

This replacement control knob restores user control over a stove or range control. It gives a simple, reliable interface for selecting heat or function when the original knob is worn, cracked, or missing. What it does

• Replaces a worn or damaged control knob to restore tactile control and accurate setting selection
• Fits onto the stove/range control shaft to allow turning to desired heat or function positions
• Common symptom fix: knob is loose, cracked, stripped, or will not turn cleanly
• Helps prevent direct contact with the control shaft and improves usability

• Usually installs by pulling the old knob straight off the control shaft and pushing the new knob fully onto the splined shaft
• Match the knob orientation to the shaft flat/spline before pushing on; do not force or hammer into place
• Disconnect power to the appliance before servicing if working near electrical components; shut off gas when applicable

This cable harness connects key electrical components to restore power and signal flow in the appliance. It replaces a damaged or faulty wiring harness to help return controls and components to normal operation. What it does:

• Carries power and control signals between the control board and components
• Replaces frayed, burned, or broken wires that cause intermittent or no operation
• Common symptoms it can address: appliance won't start, controls unresponsive, intermittent cycles, or error codes related to open/shorted circuits
• Helps ensure secure connector mating and correct signal routing when installed properly

• Disconnect power at the breaker or unplug the appliance before starting any repairs
• Compare the new harness to the old one and follow the appliance wiring diagram for correct routing and connector placement
• Secure connectors fully; avoid sharp bends or pinching the wires during reassembly