Parts for Bosch HBN642AUC/01: Control Panel Parts

This is the outer mounting frame used to support and align the appliance door and front assembly for a secure fit and proper operation. Replaces a damaged or bent frame to restore correct door alignment and appearance. What it does

• Provides structural support for the door/front panel and mounting points for hinges and trim
• Helps maintain proper door alignment and prevents rubbing or binding during opening/closing
• Commonly replaced when the frame is bent, cracked, or visibly damaged
• Can resolve fit-and-seal issues caused by a warped or broken front frame

• One outer mounting frame

• Disconnect power and water before beginning any repair
• Remove surrounding trim or inner panel to access mounting screws and hinge attachments
• Handle any attached glass or trim pieces carefully to avoid breakage
• Tighten hardware to manufacturer torque where specified and test door alignment after installation

Circuit board spacer for wall ovens. Maintains proper spacing between electronic control boards. Replace if broken, cracked, or missing to prevent board damage.

This selector switch allows you to choose different cooking modes for your convection oven including bake, broil, convection bake, and other specialized functions. It directs power to the appropriate heating elements and activates the convection fan when needed. Replace this switch if you can't select certain cooking modes, if the oven operates in the wrong mode, or if the switch feels loose or unresponsive.

This is a hose used in an oven or range to route steam, water, or air between internal components. It connects to fittings within the appliance and helps maintain proper fluid or vapor flow during operation. Replace this hose if it is cracked, kinked, leaking, or has become brittle with age, which can cause water leaks or reduced performance.

Red indicator light for wall ovens signals heating status. Replace when light fails to illuminate or stays on constantly. Verify compatibility with your model.

M4.2 x 9.5mm mounting screw for wall ovens. Secures interior panels, brackets, and components. Replace if stripped, missing, or damaged during repairs.