Parts for Dacor ERDE36NG: Control Panel Parts

This wafer-head Phillips screw (#8 x 3/8 in) is a factory fastener used to secure panels, brackets, and covers in compatible appliances. Replace a missing or damaged screw to restore a tight, properly aligned fit. What it does:

• Secures sheet-metal or plastic components to the appliance chassis or subassemblies
• Helps maintain proper alignment and reduce vibration or rattling
• Replaces lost, stripped, or corroded screws of the same size and type
• Used at panel, bracket, and cover mounting points designed for this fastener

• One wafer-head Phillips screw (#8 x 3/8 in)

• Disconnect power (and gas, if applicable) before servicing
• Start threads by hand to avoid cross-threading; use a #2 Phillips driver
• Do not overtighten, especially into plastic or thin sheet metal
• Replace only with the same size/type fastener removed to ensure proper fit

This wafer head screw secures panels, brackets, and other components inside your appliance. Replacing worn or missing hardware restores a tight fit, reduces vibration and rattles, and keeps assemblies properly aligned for reliable performance.

• Fastens panels, brackets, or trim with a low-profile wafer head for even clamping
• Replaces stripped, corroded, or missing hardware (#8 x 3/8)
• Helps maintain alignment and reduce vibration or rattling noises
• Restores secure mounting for safe, stable operation

• Disconnect power; also shut off gas before servicing
• Support the panel or component while removing/installing hardware
• Hand-start threads to avoid cross-threading; tighten snugly without overtightening
• Replace screws one at a time to maintain alignment

This Dacor oven display control board service kit includes the sensor probe and two ceramic wire connectors. All parts must be installed.