Parts for Electrolux E30EW75DSS1: 03 - Control Panel Parts

This replacement mounting bracket secures internal assemblies and keeps panels and components properly aligned for reliable operation. Use it to restore solid support where a damaged or missing bracket causes loose parts or misalignment. What it does

• Provides a secure mounting point for appliance panels and internal components
• Restores alignment to doors, panels, or assemblies that shift or sag
• Reduces rattling and vibration caused by broken or loose supports
• Re-establishes factory fitment at the original mounting location

• Disconnect power before servicing the appliance to avoid shock or injury
• Handle metal edges carefully; wear gloves to protect your hands
• Use basic hand tools to remove fasteners and align the bracket to factory mounting points

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts

This appliance screw fastens panels, brackets, and other components inside the unit. Replace a missing, rusty, or stripped fastener to restore a secure fit and help prevent rattles, misalignment, or premature wear.

• Secures appliance components such as panels, brackets, and covers
• Restores proper fit when an original screw is missing or stripped
• Helps reduce vibration and noise from loose parts
• Common signs: loose or misaligned parts, rattling, or a missing screw

• Disconnect power before servicing
• Match the new screw to the original for size and thread before installing
• Hand-start threads to avoid cross-threading; do not overtighten
• Reuse any original washers or clips if they were used with the old screw