Parts for Electrolux EW27EW65GW2: 03 - Control Panel Parts

This is a control board intended for use with refrigerators. It is an integral part of the appliance that controls many of the components inside the refrigerator, such as the fans and compressor. It collects information from all the sensors in the appliance, such as how often the doors are opened and how long the compressor runs. If the control board is damaged, it may cause cooling issues, erratic behavior, or prevent the refrigerator from working.To replace the control board, make sure the refrigerator is powered off for safety. A basic set of tools and work gloves will be needed for the process. Remove the cover for the control board and detach the wires so the original control board can be taken off the appliance. Install the new control board, lock the tabs, and connect the wires. Reinstall the cover and return power to the refrigerator.The control board is an authentic OEM replacement part that is directly sourced from the manufacturer. It is sold as an individual component. This part is designed to be used with ranges, ovens, and stoves by Electrolux and Frigidaire.

A single replacement mounting screw used to secure appliance panels, trim, or small brackets. Restores proper fastening so parts stay aligned and eliminates loose or rattling components. What it does:

• Fastens panels, brackets, or trim pieces to the appliance frame
• Secures components that vibrate or shift during normal use
• Helps stop rattling, misalignment, or gaps caused by a missing or loose screw
• Works as a direct hardware replacement where the OEM screw is required

• One screw

• Use the correct driver and size to avoid stripping the head
• Tighten until snug; do not over-torque to prevent thread damage
• Disconnect power or follow appliance safety procedures before accessing internal components
• Replace all like fasteners for best fit

This is a #8 screw, 0.500 inch long, used to secure panels and components in appliances. It provides a correct-fit fastener for repairs where the original #8 x 1/2" screw was required, restoring proper assembly and stability. What it does:

• Fastens trim, panels, brackets and small components where a #8 x 1/2" screw is specified
• Holds parts securely to prevent rattling, gaps or loose panels
• Replaces worn, stripped or missing screws to restore proper fit
• Appropriate for common interior and exterior appliance mounting points

• Use the correct screwdriver (typically Phillips) and avoid over-tightening to prevent strip or damage
• Disconnect power and follow appliance manufacturer safety instructions when accessing internal parts