Parts for Electrolux FFLG2022MW2: 04 - Control Panel Parts

Fix a laundry center that won't start cycles or requires constant resetting. This electronic control board restores user interface and timed functions.

Replacement control knob for laundry center. Attaches to control shaft for selecting settings. Replace if original is cracked, loose, missing, or stripped.

Fix a washer dryer combo that won't start, beeps but won't run, or leaves clothes soaking wet. This electronic control board restores normal cycle operation.

This round on/off switch replaces the worn or broken power control on compatible appliances, restoring reliable on/off operation and user control at the front panel. Designed to match OEM fit and function for direct replacement. What it does:

• Provides a simple on/off user control for the appliance's power circuit
• Re-establishes consistent electrical contact when the original switch fails
• Commonly fixes symptoms like no power from the control location, intermittent power, or a switch that won't stay on
• Operates as the primary user-actuated power control for the associated circuit

• One round on/off switch

• Disconnect power to the appliance before testing or replacing the switch to avoid shock
• Verify correct wiring location and connectors before removing the old switch; transfer any wiring harness or connectors exactly
• Handle with care to avoid damage to the switch actuator or mounting tabs

This electrical switch controls a specific function within your appliance's circuit. When contacts wear or fail, the unit may not start or selected options won't engage. Replacing the switch restores proper signaling and dependable operation.

• Opens and closes an electrical circuit for its assigned function
• Sends the correct on/off signal to the control or motor circuit
• Common failure symptoms: no start/response, options not engaging, intermittent operation, or related error codes
• Can be checked with a continuity test; replace if contacts are stuck open or closed

• Disconnect power at the breaker; for gas dryers, also shut off gas supply
• Access the switch location and note wire positions (take a reference photo)
• Transfer wires to the new switch one at a time and secure the mounting
• Reassemble and run a test cycle to verify proper operation

Pan head mounting screw for dryers. Secures internal components and panels. Replace if stripped, missing, or damaged during appliance maintenance.

Wire harness for laundry center units. Connects electrical components inside the cabinet. Replace if wires are frayed, connectors are damaged, or harness is broken.

Secures and organizes wires inside your appliance. Replace if broken, loose, or missing to prevent wire damage. Verify fit with your model number.

Fix a laundry center that won't start or respond to controls with this switch. Common fix for unresponsive buttons or cycle selection issues. DIY-friendly.

Replace a faulty switch in your laundry center when the unit won't start or cycle properly. This switch restores normal operation. DIY-friendly repair.